Filter
Top Products
76
Detailed Settings for Each Function ([EDIT] Button)
“Formatting” is the operation of returning the RD-300GX’s
internal memory to its factory-set state, or the operation of
preparing USB memory for use with RD-300GX.
USB memory cannot be used with the RD-300GX unless it is
formatted suitably for the RD-300GX.
If you’re using newly purchased USB memory, you must first
format it on the RD-300GX.
When you format the USB memory, all data
previously saved on that memory will be erased.
Before you carry out a format, make sure that the
USB memory does not contain important data you
need to keep.
1.
Press the [EDIT] button, getting the indicator to light.
The Edit Menu screen appears.
2.
Use the [DEC] [INC] buttons to select “File,”
then press the [ENTER] button.
3.
Press the [DEC] [INC] buttons to select
“Format,” then press the [ENTER] button.
4.
Use the [DEC] [INC] buttons to select the media
that you want to format.
5.
Press the [ENTER] button.
The confirmation message appears.
fig.disp
If you do not want to format the media, press the [EXIT/
SHIFT] button.
6.
Press the [ENTER] button once again to execute
the Format operation.
All the contents of the memory will be erased.
7.
Press the [EDIT] button, extinguishing its
indicator.
“Executing...” appears in the display while the format
is in progress. Be sure never to turn off the power.
Don’t remove the USB memory until formatting is
completed.
You can change a variety of settings related to song playback. (p. 40)
When playing songs on the RD-300GX, you can choose
whether to play songs individually or play all songs
successively.
This lets you shift the playback key of a song in semitone steps.
This also applies to Audio Key playback (p. 42).
When playing back audio files, this causes sounds located in
the center (e.g., vocals or melodic instruments) to be reduced
in volume.
This also applies to Audio Key playback (p. 42).
For some songs, using the Center Cancel function
may affect the tonal charactor.
Formatting Memory (Format)
Value Description
INT
The RD-300GX’s internal memory will be formatted.
USB
The USB memory connected to the USB MEMORY
connector on the rear panel will be formatted.
NOTE
NOTE
NOTE
Settings Related to Song
Playback (Song Function)
Selecting the Song Playback Method
(Play Mode)
Parameter
Value Description
Play Mode
ONE
SONG
When you play back a song,
only one song will play;
playback will stop at the end of
that song.
ALL
SONG
The songs in internal memory or
in USB memory will play
consecutively.
Changing the Key of the Song
Playback (Playback Trans)
Parameter Value
Playback Trans
(Playback Transpose)
-6–0–+5
Performing Along with a Audio File
(Center Cancel)
Parameter
Value
Center Cancel
OFF, ON
NOTE
RD-300GX_e.book 76 ページ ２００８年２月１４日 木曜日 午後１時２６分