Filter
Top Products
72
Detailed Settings for Each Function ([EDIT] Button)
The RD-300GX lets you store Setup data in internal memory or
in USB memory connected to the USB MEMORY connector on
the rear panel.
A single, individual file containing a collection of 32 Setups
registered to the RD-300GX is called a “Setup file.”
This Setup file can be saved in the RD-300GX’s internal
memory or on USB memory (sold separately) connected to the
USB MEMORY connector.
1.
Press the [EDIT] button, getting the indicator to
light.
The Edit Menu screen appears.
2.
Use the [DEC] [INC] buttons to select “File,”
then press the [ENTER] button.
3.
Press the [DEC] button to select “Save SETUP,”
then press the [ENTER] button.
The following screen appears.
fig.disp
4.
Use the [DEC] [INC] buttons to select the
destination in which the Setups are to be stored.
5.
Press the [ENTER] button.
The following screen appears.
fig.disp
6.
While continuing to hold down the [EXIT/
SHIFT] button, use the [DEC] [INC] buttons to
move the cursor to the positions where the
characters are to be input.
7.
Use the [DEC] [INC] buttons to enter the name.
Names can consist of up to 16 characters.
The following characters are available.
space ! # $ % & ' ( ) + , - . 0–9 ; = @ A–Z [ ] ^ _ ` a–z {
} ~
You can’t save a Setup file with a name that starts
with a “. (period)”. Do not use a “. (period)” at the
beginning of the name.
8.
Repeat steps 6–7 to input the name.
9.
When you’ve finished entering the file name,
press the [ENTER] button.
The following screen appears.
fig.disp
If you do not want to save the Setup file, press the [EXIT/
SHIFT] button.
10.
Press the [ENTER] button once again to save
the Setup file.
“Executing...” appears in the display while the save
is in progress. Be sure never to turn off the power.
If a file with the same name has already been
saved, the confirmation message “Overwrite OK?”
appears. To overwrite the file, press the [ENTER]
button; to save the file under a different name,
press the [EXIT/SHIFT] button.
11.
Press the [EDIT] button, extinguishing its
indicator.
Here’s how to load a previously saved Setup file.
The current settings are erased when a Setup file is
called up. Be sure to save you would like to keep
first before calling up.
1.
Press the [EDIT] button, getting the indicator to
light.
The Edit Menu screen appears.
2.
Use the [DEC] [INC] buttons to select “File,”
then press the [ENTER] button.
File Management (File)
Saving a Setup File (Save SETUP)
Value
Description
INT
The data will be stored in the RD-300GX’s internal
memory.
USB
The data will be stored on USB memory connected
to the USB MEMORY connector on the rear panel.
Calling Up Setup File (Load SETUP)
NOTE
NOTE
RD-300GX_e.book 72 ページ ２００８年２月１４日 木曜日 午後１時２６分