Filter
Top Products
31
Performance
When changing the Tone assigned to a Zone, use the ZONE SELECT button to specify
the Zone with the Tone you want to change.
fig.Q1-20p
1.
Press the ZONE SELECT button so the ZONE SELECT indicator for the Zone you wish to
select is lit or blink.
The indicator of the currently selected TONE SELECT button will light in the same color as the
indicator of the selected Zone.
2.
Use the TONE SELECT buttons to select the Tone category, and then use the [DEC] [INC]
buttons to select a Tone.
The [DUAL] button’s indicator will blink if the UPPER 2 Zone is not on, and the [SPLIT]
button’s indicator will blink if the LOWER Zone is not on. If you want to play sounds
in each Zone, press the corresponding button so the indicator is lit.
With the RD-300GX, each of the parts that is performed using the internal sound
generator is referred to as an Internal Zone.
For each Zone (UPPER 1, UPPER 2, and LOWER), you can use the ZONE LEVEL sliders
to adjust the volume of an individual Zone.
fig.Q1-21pe
Use the VOLUME slider when adjusting the overall volume level (p. 20).
Changing the Tone for a Zone (ZONE SELECT Button)
Adjusting the Volume Level for Individual Zones (ZONE LEVEL Sliders)
INTERNAL indicator is lit
Zones to which Tones from external sound modules are assigned are called External
Zones. With the RD-300GX, you can control both the External and Internal Zones in the
same manner. For more on the control of External Zone, refer to “Adjusting the Volume
of Each Zone (External Zone)” (p. 57).
RD-300GX_e.book 31 ページ ２００８年２月１４日 木曜日 午後１時２６分