Filter
Top Products
25
Playing in Patch Mode
Playing in Patch Mode
Making Arpeggiator Settings
1.
Access the PATCH PLAY screen (p. 21).
2.
At the bottom of the screen, touch <Common>.
3.
In the left side of the screen, touch the Arpeggio> tab.
The PATCH Edit Com Arpeggio screen appears.
fig.02-09_50
In this screen you can set the following arpeggiator parameters.
Arpeggio Switch:
Switches the Arpeggiator on/off.
Hold:
Switch between Hold On/Hold Off for the Arpeggiator
performance.
Patch Tempo:
Specify the tempo of an arpeggio.
Octave Range:
Specify the range of the arpeggio performance,
in octave units.
KBD Velo:
Specify the note strength of the keys you play.
Accent Rate:
Vary the strength and note length of the accents to
modify the rhythmic feel (groove) of the performance.
Motif:
Specifies how the arpeggio will be sounded.
Shuffle Duration:
Create shuffle rhythms by modifying the
timing at which notes are sounded.
Shuffle Resolution:
Specify the timing of the notes in terms of
note value.
For details regarding each parameter, refer to
“Arpeggio”
(p.
40).
Arpeggiator settings can be saved with each patch as part of the
patch settings. This means that you can create patches that
contain the most effective settings.
Creating an Original Arpeggio
Pattern (Pattern Edit)
You can create your own
arpeggio pattern
that specifies how an
arpeggio will be sounded. This gives you even more interesting
ways to use arpeggios.
An arpeggio pattern is a set of data that can be up to 32 steps
(horizontally) x 16 lines (vertically).
An arpeggio pattern can be saved for an individual patch as part
of the patch settings. This means that you can create a patch
designed specifically for that arpeggio pattern (or vice versa).
About the Pattern Edit Window
1.
Access the PATCH Edit Com Arpeggio screen (p. 25).
2.
Touch <Pattern Edit>.
The Pattern Edit window will appear.
fig.02-09a.e
State
Specifies the status of each line.
NOTE:
Note pitch
CTRL:
Control change
Note/CC (Note/Control Change)
Specifies the note number or control change number assigned to
each line. If Status is “NOTE,” this will be a note number (C-1–G9). If
Status is “CTRL,” this will be a control change number (0–127).
Pattern Input Area
This area is where you input or edit notes or control changes. The
symbols have the following meaning:
●
: Note
=: Tie
❍
: Control change
Value
Shows the velocity of the note or the value of the control change
selected in the pattern input area.
Cursor
Pattern input area