Filter
Top Products
77
Settings Common to All Modes (System Mode)
Settings Common to All Modes (System Mode)
Part MIDI
fig.05-04_50
Part1–16 Rx Sw (Part 1–16 Receive Switch)
For each part, specify whether MIDI messages will be received (ON),
or not (OFF).
If this is “ON,” you can play that part from an external MIDI device.
Normally, you will select “ON” only for part 1 which you play from
the keyboard.
Value: OFF, ON
Part 1–16 Rx Ch (Part 1–16 Receive Channel)
Specifies the MIDI receive channel for each part.
Value: 1–16
Performance data directed to the V-Synth itself will be
transmitted on the channel you specified for part 1.
Controller Settings (Controller)
Tx
fig.05-05_50
Patch Tx Ch (Patch Transmit Channel)
Specifies the transmit channel of MIDI messages in Patch mode. If
you do not want to transmit MIDI messages to external MIDI
devices, turn this parameter “OFF.” If you want the transmit channel
to always match the Patch Receive Channel, set this parameter to
“RX CH.”
Value: 1–16, RX CH, OFF
Tx PC (Transmit Program Change Switch)
Specifies whether Program Change messages will be transmitted
(ON) or not (OFF).
Value: OFF, ON
Tx Bank (Transmit Bank Select Switch)
Specifies whether Bank Select messages will be transmitted (ON) or
not (OFF).
Value: OFF, ON
Tx Active Sens (Transmit Active Sensing
Switch)
Specifies whether Active Sensing messages will be transmitted (ON)
or not (OFF).
Value: OFF, ON