Filter
Top Products
Owner’s Manual
Removing rubber stoppers for rack mount installation
101
Appendix
Removing rubber stoppers
for rack mount installation
The MOTIF-RACK ES has four removable rubber stoppers. If the
MOTIF-RACK ES does not fit in your rack mount cabinet because
the stoppers hit against another device, remove the stoppers as
described below.
Before removing the stoppers, make sure you have a sharp, thin
tool — such as a safety pin or straightened paper clip.
Do not use any tool that easily snaps or bends, such as a toothpick or thin wire.
1. Turn the MOTIF-RACK ES power off, and disconnect the
power cord.
Also, if the MOTIF-RACK ES is connected with other external
device(s), disconnect the device(s).
2. Turn the MOTIF-RACK ES upside down.
3. Insert the tool between the rubber stopper and the
plastic rivet (as shown).
4. Pull the rivet up and out of the panel.
5. Pull out the rubber stoppers.
To re-attach the removed stoppers, reverse the procedure above,
inserting the rivets perpendicularly.
Removing the Plug-in Board from the MOTIF-
RACK ES
1. Press down hooks 2 in the direction as shown in the
illustration and take the board out from hooks 2 by lifting up
the one side.
2. Pull out the other side of the board from hooks 1 while
pressing down hook 1 as shown in the illustration.
3. Pull out the cable connector from the Plug-in Board
connector.
hook 2
hook 1
CAUTION
Sharp tool
Rubber stopper
Rivet