Filter
Top Products
Owner’s Manual
Performance mode Performance Edit
34
Quick Guide
4. Select the desired display with the PAGE [E][F] buttons
and change the settings.
To change the display page, use the PAGE [E][F] buttons. Select
the desired parameter with the cursor [L][M] buttons and change
the settings by using the data dial.
The following briefly describes the main parameters.
Common Edit
n Functions assigned to the external controllers depend on the settings of
each Part’s Voice edited in the Voice Edit mode.
Part Edit
5. Repeat steps 3 - 4 as desired.
6. Name the edited Performance.
Select the General display in the Common Edit, and then input a
name in the Name parameter.
For detailed instructions on naming, refer to page 50.
7. Store the edited Performance to the User Bank (USER)
of the Performance.
For details, see page 49.
Switching Part On/Off (Mute) and selecting
the Part
Each time you press the [MUTE/SEL/ENTER] button, the on/off
status of the LED changes.
When the LEDs are lit (Mute)
You can mute any Part by pressing the corresponding Part/
Element button [1/5/9/13] to [4/8/12/16].
You can check which Part is muted by checking the lamps of the
Part/Element buttons. The LEDs of the muted Part buttons are
turned off and the active Part buttons light.
When the LEDs are off (Select)
You can select any desired Part by pressing the corresponding
Part/Element button [1/5/9/13] to [4/8/12/16]. If you select the
muted Part, the LED of the button flashes.
n You can also switch the on/off status of each Part in the Multi mode.
General For setting general parameters in Common Edit,
such as Performance Name, Portamento, etc.
MEQ (Master EQ) For setting the Master EQ for each
Performance. Master EQ also features separate
EQ shape parameters for the Low and High
bands, as well as the Frequency, Gain and Q
controls for each band.
MEF (Master Effect) For setting the Master Effect type and other
parameters.
CtrlAsn (Control Assign) For setting the Control Numbers generated by
using an external MIDI controller.
Output For setting the Voice output parameters such as
Volume, Pan, and Send Level of Reverb/Chorus
Effect.
EG (Envelope Generator) For setting time variance parameters such as
Attack, Decay, Release and Sustain, or the filter
parameters such as Cutoff and Resonance.
TIP
Display name
Parameter name
Parameter
value
Voice Determines the Voice parameters (Voices
assigned to the Part, Note/Velocity Range,
Arpeggio On/Off, Portamento setting, Pitch
Bend setting, etc.) for each Part. You can also
set the Voice for assigning to each Part and
Note/Velocity Range of each Part in the
Performance Voice Assign mode (page 31).
Output Assigns each individual Part’s Voice to be
output from a specific output jack on the rear
panel. You can also set the Voice output
parameters such as Volume, Pan, and Send
Level of Reverb/Chorus Effect.
Tone For setting basic synthesizer parameters, such
as Oscillator, Pitch, Filter, and Amplitude.
EQ (Equalizer) For setting the Equalizer for each Part.
RcvSw (Receive Switch) For setting whether Control Change, Pitch
Bend, Modulation Wheel messages, etc. for
each Part are recognized or not.
Enter the desired
Performance name.