Filter
Top Products
Owner’s Manual
Basic Structure
Effect block Effect connection in each mode (Effect Connection Edit)
62
Performance mode
The Effect parameters in the Performance mode are set for each Performance and the settings are stored as a User Performance.
Multi mode
The Effect parameters in the Multi mode are set for each Multi and the settings are stored as a User Multi.
n The Insertion Effect, Plug-in Insertion Effect, and the System Effect cannot be applied to Parts 17-32 (when using the Multi-part Plug-in Board PLG100-XG).
n The Part EQ cannot be applied to Parts of the Plug-in Board.
n The System Effects (Reverb, Chorus), the Master EQ, and the Master Effect are not applied to the sound output through the ASSIGNABLE OUTPUT jacks. (Only the Part EQ
and the Insertion Effect are applied.)
1
2
*1
*2
*3
[SHIFT]+[PERFORM] → select Performance →
select Effect Connection Edit by pressing
[EFFECT] once or twice
Tone Generator
block
Part 1
Part EQ
Part 1
Insertion Effect
(VCE INS)
Master Effect
Master EQ
Output
[SHIFT]+[PERFORM] → select Performance →
select Performance Edit by pressing [EDIT] once
or twice → [SHIFT] + [COMMON] → MEF display
*1 [SHIFT]+[PERFORM] → select Performance →
select Performance Edit by pressing [EDIT] once or
twice → [MUTE/SEL/ENTER] (LED turns off) →
select Part → EQ display
*2 [SHIFT]+[PERFORM] → select Performance →
select Performance Edit by pressing [EDIT] once
or twice → [SHIFT] + [COMMON] → Output
display
*3 [SHIFT]+[PERFORM] → select Performance →
select Performance Edit by pressing [EDIT] once or
twice → [SHIFT] + [COMMON] → MEQ display or
General display → MEQ parameters
The Insertion connection type
depends on the setting of the Voice
assigned to the selected Part.
Send
Level
Return
Level
System Effect
Reverb (REV), Chorus (CHO)
1
2
*1
*3
*2
*4
[MULTI] (LED lights in green) → select Multi → select Effect
Connection Edit by pressing [EFFECT] once or twice
System Effect
Reverb (REV), Chorus (CHO)
Send
Level
Return
Level
Tone Generator
block
Part 1
Insertion Effect
(VCE INS)
Master Effect
Master EQ
Output
Tone Generator block
Part 17-32
(When the Multi-part Plug-in Board
PLG100-XG has been installed)
Part 1
Part EQ
Part 1-16
Plug-in Part 1-2
(When the Single-
part Plug-in Board
has been installed)
[MULTI] (LED lights in green)
→ select Multi → [EDIT] →
[SHIFT]+[COMMON] → MEF
display
*2 [MULTI] (LED lights in green) → select Multi → [MUTE/SEL/
ENTER] (LED turns off) → [MUTE/SEL/ENTER] (LED turns off)
→ select Part → EQ display
*3 [MULTI] (LED lights in green) → select Multi → [MUTE/SEL/
ENTER] (LED turns off) → [MUTE/SEL/ENTER] (LED turns off)
→ select Part → Output display
1. You can select the desired Part(s) (up to eight) to which the
Insertion Effects are to be applied.
[MULTI] (LED lights in green) → select Multi → [MULTI] (LED
lights in red) → Effect display → “InsEF”
The Insertion Effect settings depend on the settings of the Voice
assigned to each Part (made in the Voice mode; page 29).
*4 [MULTI] (LED lights in green)→ select Multi → [EDIT] →
[SHIFT]+[COMMON] → MEF display or General display →
MEQ parameters