Filter
Top Products
Owner’s Manual
Multi mode Multi Mixing
83
Multi mode
Multi Mixing
Multi Voice Edit
From Multi Voice Edit, you can edit the detailed settings of the Normal Voice assigned to each Part. These are the same as in the Voice
Common Edit mode (page 65) and the Voice Element Edit mode (page 68). Please note that certain parameters cannot be edited in the
Multi Voice Edit.
n Only Normal Voices can be edited.
Multi Voice Effect Edit
From Multi Voice Effect Edit, you can edit the Insertion Effects of the Voice assigned to each Part. Same function as the Voice Effect Edit
(page 85). Please note that the System Effects cannot be edited in the Multi Voice Edit mode.
[MULTI] (LED lights in green) → select Multi → [MULTI] (LED lights in red) → select each display with PAGE [E][F]
Voice
Determines the Voices for assigning to each Part.
VoiceNo.
Voice Number Determines the Voice Bank and Voice Number for each Part.
n The Category Search function can also be used to select Voices here, except for Voices of the MultiPart Plug-in Parts
17 - 32 (when the PLG100-XG has been installed).
Bank MSB/Bank LSB
Bank Select MSB/LSB
Output
From this display you can set the Pan and Volume for each Part.
Pan
Pan Determines the stereo pan position for each Part.
Settings: L63 (far left) ~ C (center) ~ R63 (far right)
Volume
Volume Determines the volume for each Part, allowing you to set the optimum level balance of all the Parts.
Settings: 0 ~ 127
Effect
From this display you can make basic effect settings for each Part – on/off status of Insertion Effects and
Send Level for the System Effect (Reverb, Chorus).
RevSend/ChoSend
Reverb Send/Chorus Send Sets the Send Level for each Part to the System Effect (Reverb, Chorus).
Settings: 0 ~ 127
DryLvl
Dry Level Sets the Dry Level sent for the Insertion Effects for each Part.
Settings: 0 ~ 127
InsEF
Insertion Effect Switch Select the Parts to which the Insertion Effects are applied. The Insertion Effects can be applied to up to eight
Parts.
Settings: on, off
(VarSend)
Variation Send This parameter is shown only when the PLG100-XG Plug-in Board is installed and any one of Parts 17-32 is
selected. This determines the Send Level sent to the Variation effects for each Part.
Settings: 0 ~ 127
[MULTI] (LED lights in green) → select Multi → [MULTI] (LED lights in red) → Multi Mixing → [MUTE/SEL/ENTER] (LED turns off) → select
Part → [SHIFT]+[EDIT]
Common Edit
Multi Voice Edit → [SHIFT]+[COMMON] → select each display with PAGE [E][F]
Element Edit
Multi Voice Edit → [MUTE/SEL/ENTER] (LED turns off) → select Element with [1/5/9/13]-[4/8/12/16] → select
each display with PAGE [E][F]
Effect Connection Edit
Multi Voice Edit → press [EFFECT] once or twice
Effect Parameter Edit
Multi Voice Edit → press [EFFECT] once or twice → select each display with PAGE [E][F]
Utility Voice modePerformance mode
Multi mode
EffectArpeggio
Reference