Filter
Top Products
114
Performance Mode
• If PartPL (Plug-in) has been selected
Set the Voice for the Plug-in Part. This screen is only
displayed if a Plug-in Board has been installed. Use
Knob [B] to select PLG INT (internal memory) and the
MSB/LSB (Plug-in Board’s Bank), and use Knob [C] to
select the Program Number.
■ Bank
❏ Settings:
PartPL (Plug-in): PLG INT (Plug-in Internal), MSB/LSB
(Plug-in Bank)
For details about Plug-in Banks (Bank Select
MSB/LSB), refer to the Owner’s Manual that came with
your Plug-in Board.
■ Number (Program Number)
❏ Settings:
PLG INT (Plug-in Internal): 1 ~ 64
MSB/LSB (Plug-in Bank): 1 ~ 128
There may be a delay when changing programs for a Plug-
in Part (since voice data and default settings need to be
sent). To change Voices for a Plug-in Part in a song, you
should insert the Program Changes in the less data-
intensive areas of the song. When selecting a Plug-in Board
Voice, you should use the Program Number of the
Parameter Change (multi-part). Details are given in the
Owner’s Manual that comes with the Plug-in Board.
In Performance Mode, the Part assignment for a Plug-in
Board is fixed at “15” for PLG.
For details about Plug-in Voices, refer to the Owner’s
Manual that came with your Plug-in Board.
• If Part17 to Part32 has been selected
You can set Voices for Parts 17 to 32 if you have a
multitimbral Plug-in board installed. Use Knob [B] to
select the Voice Bank and Knob [C] to select the
Program Number.
■ Bank/Number (Bank/Program Number)
❏ Settings: Refer to the Owner’s Manual that came with the
Plug-in board.
This setting is only held temporarily and cannot be
stored with the Performance.
MIXíVce) Bank Number
Part17 NORM/001:001(A01)[Pf:GrandPno]
MIXíVce) Bank Number Ctgry Search
PartPL NORM/001:128(H16)[Pf:GrandPiano]
Part (Settings for each Part)
You can edit each Part in a Performance. Use Knob [A]
to select the Part, then set its parameters. The
following six screens are available, though their
contents will vary according to the Part selected.
• Part Mixer
• Part Tone
• Part Layer
• Part Receive switch
• Part Controller
• Part Insertion Effect
Part Mixer
You can set various Voice output parameters for each
Part. The following two screens are available.
MIX Vce (Mix Voice)
MIX Level
MIX Vce (Mix Voice)
You can assign a Voice to each Part. Use Knob [A] to
select the Part, then set its Voice parameters.
The display will vary as follows according to the Part
selected.
• If Part01 to Part16 has been selected
You can use the same method as the Category Search
(Page 62) to set the Voice.
■ Memory (Voice Memory)
❏ Settings:
PRE1 (Preset 1), PRE2 (Preset 2), INT (Internal Normal),
EXT (External Normal), PRE (Preset Drum), INT
(Internal Drum), EXT (External Drum)
■ Number (Program Number)
❏ Settings:
1 ~ 128 (for Normal Voices), DR1 ~ DR8 (for Preset
Drum), DR1 ~ DR2 (for Internal/External Drum)
Details about Categories are given in the Category List
on Page 65.
MIXíVce) Memory Number Ctgry Search
Part01 PRE1:128(H16)[Pf:GrandPiano]