Filter
Top Products
134
Utility Mode
Synchronize the tempo settings of the S30
and the Plug-in Board.
If you are using a Plug-in Board capable of
generating arpeggio patterns, you can synchronize
its tempo with that of the S30.
1Enter Utility Mode and select the PLG MIDI
screen. Then use the appropriate knob to set the
Clock parameter to “on.”
2Enter Voice Mode, select the Plug-in Voice of the
respective Plug-in Memory, then enter Voice Edit Mode.
3 Use knob [A] to select “Elem,” as shown at the
bottom left of the screen.
4Use the [PAGE] knob to select the name of the
Plug-in Board, as shown at the bottom left of the
screen. Then enter the Plug-in native part
parameter screen.
5Use the [PAGE] knob to select the Plug-in native
part parameter for the tempo. Then use the
appropriate knob to select MIDI (midi).
Now, the tempo of the Plug-in Board is
synchronized with the MIDI clock signal received
from the S30.
To synchronize with an external MIDI clock source,
enter Utility Mode and set the Sync parameter of
the MIDI Other screen to “MIDI.”
Utility Job Mode
In Utility Job Mode, you can restore your synthesizer’s
factory default settings (Factory Set). There is only
one screen in this Mode.
Factory Set (Restore Factory
Defaults)
You can restore the synthesizer’s default Internal
Voices and Performances, as well as its System and
other settings.
Once you edit any settings, their factory defaults will
be overwritten and lost.
You can restore the factory default settings as follows.
When you restore the factory default settings, all the
current settings for the all the Internal Voices and
Performances will be overwritten with the factory defaults.
Make sure you are not overwriting any important data.
You should back up any important data to Memory Card,
or to some external device beforehand.
1Press the [JOB] key in Utility Mode. You will see the
Factory Set screen.
2When you press the [ENTER] key, you will see a
confirmation message.
3Press the [INC/YES] key to execute the Factory Set
job. You will see the “Completed.” message
displayed after the job has completed. You can
cancel a job while it is being executed by pressing
the [DEC/NO] key.
4Press the [EXIT] key to return to Utility Mode.
UTIL Factory Set)
Job
STOREVOICE
M
ODE
UTILITY
EDIT JOB
PLAY
/
STOP
CARD
SEQ
PLAY
PERFORM
COMPARE