Filter
Top Products
112
2. Select the desired item with the [JOG] dial and press
the [ENTER/YES] key.
The selected item will be set.
On/Off of phantom power setting [“Phantom Power”]
ON/OFF of phantom power provided at INPUT 7 and 8 (XLR-3-31) can be setup.
1. Select “Phantom Power” in the menu selection display and
press the [ENTER/YES] key.
The currently set will flash. “Off” will flash in the initial
setting.
2. Select the desired comp. Channel with the [JOG] dial
and press the [ENTER/YES] key.
The selected item will be set.
* Initial setting: [Off]
* Options: [Off], [13-14] or [15-16]
# Common to all programs in the same disc.
# The setup content cannot be saved/loaded as song
data.
# Although the setup content will not be held at switch
off of power, it can be saved as a scene memory.
Compressor Channel Setting [“Comp. Channel”]
In the "Setup of the compressor channel" menu, the channel in which the VF-16 internal compressor function
should be activated can be setup. The compressor can be made to function in channels 13-14 or 15-16.
Regardless to this setting, the compressor can be applied at all times to the master channel.
1. Select “Comp. Channel” in the menu selection display
and press the [ENTER/YES] key.
The currently set will flash. “Off” will flash in the
initial setting.
3. Press the [EXIT/NO] key (or [STOP] key) to exit from the
SETUP mode.
Off Compressor can be applied only in
(Initial setting) the master channel.
13-14 The compressor can be applied to
channels 13/14 and the master
channel.
15-16 The compressor can be applied to
channels 15/16 and the master
channel.
3. Press the [EXIT/NO] key (or [STOP] key) to exit from the
SETUP mode.
Off (Initial setting) Phantom power will not be supplied.
On Phantom power is supplied to INPUT
7 and 8. The PHANTOM LED will be
lit.
<Note>
The VF-16 internal compressor can be made to func-
tion only in the channel setup here and the master
channel. However, editing of EQ in channels other than
the master channel, is not permissible.
<CAUTION!>
Do the following before using the phantom power:
* When connecting a condenser microphone to MIC INPUT
7 and 8 (XLR-3-31 type) of the VF-16, be sure this
microphone requires phantom power (+48V).
* Switch ON the phantom power after connecting the
condenser microphone.
* Always mute the VF-16 output when switching ON-OFF
the phantom power and when connecting or
disconnecting the microphone cable from the VF-16.
* Always switch OFF the phantom power when connecting
a dynamic microphone to INPUT 7 and 8(XLR-3-31
type). Otherwise, a malfunction could occur.
Phantom power cannot be used with the following equipment:
* Unbalanced output microphones.
* High impedance microphones.
* In a microphone where there is voltage leak between
pin 2/pin 3 and pin 1 of the microphone cable canon
connector.
* Old model ribbon microphones of the ground center
tap output type.
• Initial setting: [Off]
• Options: [On] or [Off]
* You can set the value for each Program individually.
* The settings cannot be saved and loaded as part of
the song data.
* The settings are maintained after you turn off the
power to the VF-16.
flashing
flashing