Filter
Top Products
113
<Important>
EQ cannot be applied to the channel (Except the mas-
ter channel) setup for the compressor.
With the compressor channel setup, if the EQ editing
mode is entered, this condition will be indicated by
the [CH STATUS/CH SEL] key LED.
The channel in which the LED (green) is blinking is an
indication that EQ editing is possible in this channel
and the channel in which the LED is not lit is an indi-
cation that EQ cannot be applied to this channel.
If a channel that cannot be EQ editing had been se-
lected, the "Can't Select!" message will blink to warn
that the operation is ineffective.
The schematic below is an example of channels 15-16
setup as the compressor channel.
This is indicating that channels 15 and 16
are setup as the compressor channel.
flashing