Filter
Top Products
27
Switching with [DISP SEL] Key
Every time the [DISP SEL] key is pressed the LCD
alternately shows the “1.
Normal Display of Current Time Base” -> “2. REMAIN
Display of Current Time Base” -> “3. MTC Time Display
Input”. The description of each display is defined
below.
1. Normal Display of Current Time Base
* Current time according to current time base.
* Program number and program title.
The first 9 characters of the program title are shown.
* Scene number and scene name.
The first 9 characters of the scene name are shown.
* Level meter of tracks 1 to 16.
* L/R master level meter
2. REMAIN Display of Current Time Base
* REMAIN time and space available in mono-track
converted units according to the current time base (the
following is the case in ABS).*1
* Format type.
* Name of hard disk.
* Level meter of tracks 1 to 16.
* L/R master level meter.
3. MTC Time Display Input
* MTC time input.
“00H 00M 00S 00F” appears if there is no time input.
* Program number and program title.
The first 9 characters of the program title are shown.
* Scene number and scene name.
The first 9 characters of the scene name are shown.
* Level meter of tracks 1 to 16.
* L/R master level meter.
*1. The REMAINING time display appears as follows
according to the time base that has been selected.
Time Base: ABS and MTC
Time Base: BAR/BEAT/CLK
*2. Icons of the program setup details appear at the
right side of the menu. Refer to examples below.
This indicates recording/no
recording setup by the “Rec Protect”
menu. The icon shown here is
indicating that it is presently set
“Off” and thus recording is possible.
This is indicating the VF-16 sampling
frequency (Fixed to 44.1kHz).
This indicates the drive setup by the
“Drive Sel” menu. The icon here is
indicating that it is set to an “E-IDE
hard disk.”
This indicates the MIDI sync output
signal setup by the “Midi Sync Out”
menu. The icon here is indicating
that it is presently set to “CLK.”
This indicates the slave type setup by
the “Slave Type” menu.
This icon is indicating that it is
presently set to “VARI.”
Frame rate figure setup by the “MTC
Frame Rate” menu is indicated here.
The icon here is indicating that it is
presently set to “25 Frames.”