Filter
Top Products
PANEL CONTROLS AND TERMINALS
15
PANEL CONTROLS AND TERMINALS
■ REAR PANEL
1POWER ON/OFF Switch
2DC IN Terminal
For connection to the supplied PA-3 AC
adaptor.
The cable clip located next to this terminal
helps to prevent accidental unplugging of the
power supply during use. Wrap the adaptor
cord firmly around the clip (as shown at right).
3PHONES Jack
For output of both the Backing sound (mono)
and the instrument/effect sound (stereo) to a set
of stereo headphones.
4Headphone LEVEL Control
For adjusting only the headphone output; this
does not affect the output of the other output
jacks.
5L/L+R OUTPUT and R OUTPUT Jacks
For stereo or mono output of the instrument/
effect sound. Connect both of these to the
corresponding left and right channels of your
stereo amplification system to take full advan-
tage of the stereo effects of the GW50. For
mono operation, connect your system to the
L/L+R jack; this provides a mono mix of the
instrument/effect sound.
6BACKING/MONO OUTPUT Jack
When only this output jack is connected, this
outputs a mono mix of the Backing Accompani-
ment, Bass and Drums sound, plus the input
instrument/effect sound. When the other
output(s) are also connected, only the Backing
sound is output from this jack.
7BACKING LEVEL Control
For adjusting the level of the Backing Accom-
paniment, Bass and Drums output.
8Input LEVEL Control
For adjusting the level of the input signal.
9INPUT Jack
For connection of an instrument (guitar, bass,
etc.). (See pages 19, 20 for more information on
input/output connections.)
5 67 890!@ #
12 34