Filter
Top Products
50
EFFECT SECTION
MANUAL MODE
Note: When the settings have been saved, “COM-
PLETED” is shown in the display and operation
automatically goes to the Memory mode.
Data Saved to an Effect Program
When you save an effect program, all the follow-
ing data is saved together with it:
* Effect types for each block
* Effect parameters (main and sub) for each block
* Bypass status of each effect block
* Noise gate setting
* Utility function settings (Connect, Group, Foot
Controller, Minimum Volume, Auto Volume)
Note: When you save the settings in the Manual
mode to an effect program, the GW50 auto-
matically gives it a name, starting with the let-
ters “MEM” and followed by the bank number
and memory number to which it has been saved
(e.g., “MEM 15”).
MANUAL JOB MODE
MANUAL JOB MODE
Saving the Manual Mode Settings to
an Effect Program
Operation —
1. After making the desired effect settings in the
Manual mode, simultaneously hold down
[MANUAL] and press [MEMORY]. (The
[MEMORY] LED and BANK/MEMORY
indicator flash.)
2. Select the destination program number with
the [–]/[+] buttons.
3. To save, select “GO” (press [SET-B]). To
cancel and return to Manual mode, select
“EXIT” (press [SET-A]).
CAUTION
Be careful when performing this operation,
since it automatically and irretrievably
erases the program at the destination.
s