Filter
Top Products
44
EFFECT SECTION
MANUAL MODE
MANUAL MODE
Editing the Sub Parameters and Noise Gate
1. Simultaneously hold down [SHIFT] and press
[SUB PARAM].
Selecting an Effect Type
The Distortion, Equalizer, Chorus and Reverb/
Delay effect blocks feature different effect types.
Press the Type switch to step through the available
effects. The LED of the selected effect lights.
Turning Individual Effects On and
Off
When not assigned to a group, individual effect
blocks can be turned on and off in the Manual
mode. To do this, make sure that MEMORY ON/
OFF is selected in the ASSIGNABLE Block (the
MEMORY LED flashes), then press the Pedal
Switch of the appropriate effect block. The LED of
the selected effect lights when the effect is on.
(For information on assigning effects to a group,
see page 45.)
Editing Parameters
Effect parameters can be edited in the Manual
mode. The Manual mode is designed to be a kind
of “blank slate” on which you can make settings as
you wish. If you create some settings in the
Manual mode that you want to keep as an effect
program, save them to a program number (see
“Saving the Manual Mode Settings to an Effect
Program,” page 50).
Editing the Main Parameters
1. Select the desired type of effect with the
Type button in each effect block.
2. Adjust the desired parameters with the knobs
in each effect block. (The display automati-
cally shows the adjusted parameter name and
value.)
2. To select a parameter, keep holding down
[SHIFT] and repeatedly press [SUB
PARAM] to step through the sub parameters
for all selected Equalizer, Chorus and
Reverb/Delay effects (indicated by the lit
green LEDs in the effect blocks) and the
Noise Gate.
Or, after step #1, release [SHIFT] and simply
press one of the effect selector buttons be-
neath the LCD ([EQ], [CHO], and [REV]) to
step through the sub parameters of the corre-
sponding effect. Pressing [CMP] or [DST]
selects the Noise Gate parameter.
3. Adjust the selected parameter with the [–]/[+]
buttons.
MANUAL MODE