Filter
Top Products
BACKING SECTION
PATTERN MODE
PATTERN MODE
77
HINT
PLAYING FILL IN PATTERNS—You can use
Pedal Switch 3 (Fill) to play the fill in pattern
at any point in a measure. In other words, if
you press the Pedal Switch on the third beat
of a measure, the fill in pattern will playback
from the third beat to the end of the
measure and then will return to the normal
pattern. Also, holding down the Fill Pedal
Switch through successive measures
continues playing the fill in pattern.
Note: If you press the Fill Pedal Switch on the last
16th note of a measure, the fill in pattern will
play in its entirety from the next measure.
HINT
PLAYING AN ENDING PATTERN—Rather than
simply stopping the pattern with [START/STOP],
you can use Pedal Switch 4 (End) to play a simple
ending pattern. Press it during the measure
previous to the intended ending.
Chord Recall
■ Selecting Chords
Operation —
1. Use the ASSIGNABLE Block Type switch to
select CHORD RECALL. (The LED next to
the function name lights.)
2. The Pedal Switches function as shown below.
Press the appropriate Pedal Switch for the
desired function. Chords can be selected
whether a pattern is playing or not.
❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉
ASSIGNABLE Block and Pedal
Switch Functions in Pattern Mode
The Pedal Switches can be used in the Pattern
mode either to select and play patterns (Backing
Control) or to change chords (Chord Recall).
HINT
USING ASSIGNABLE BLOCK PEDAL SWITCH
TO SWITCH BETWEEN BACKING CONTROL
AND CHORD RECALL—Although the Type
switch in the ASSIGNABLE Block is normally
used to select Backing Control and Chord
Recall, you can use the ASSIGNABLE Block
Pedal Switch in the Pattern mode to switch
between the two, after either one has been
selected.
Note: When pressing [SONG/PATTERN] to select the
Pattern or Song mode, Backing Control will au-
tomatically be selected.
Backing Control
■ Selecting and Playing Patterns
Operation —
1. Use the ASSIGNABLE Block Type switch to
select BACKING CONTROL. (The LED
next to the function name lights.)
2. The Pedal Switches function as shown below.
Press the appropriate Pedal Switch for the
desired function.
Selects
chord 1
Selects
chord 2
Selects
chord 3
Selects
chord 4
Starts/stops
pattern play
Switches to Backing Control (Hold this and
press one of Pedal Switches 1 – 4 to assign
current chord to the pressed Pedal Switches.)
Decreases pattern
number by 2
(every other odd
numbered pattern)
Increases pattern number
by 2 (every other odd
numbered pattern)
Plays fill in pattern
(during pattern
play only)
Plays ending pattern
(during pattern play only)
Starts/stops
pattern play
Switches to Chord Recall (Hold this and press
one of Pedal Switches 1 – 4 to assign current
chord to the pressed Pedal Switch.)