Filter
Top Products
65
EFFECT SECTION
EFFECTS AND PARAMETERS
LEFT DELAY FEEDBACK (DL FB, P.L) —
Range: 0 ~ 99%
Determines the amount of regeneration of the
left signal’s delayed repeats. The higher the
value, the greater the number of repeats. Since
the pitch shift is applied to each delayed repeat,
each successive repeat has a different pitch.
RIGHT DELAY TIME (DL TIM, P R)
Range: 0.1 ~ 10 ms
Determines the time that the right pitch-shifted
signal is delayed.
RIGHT DELAY FEEDBACK (DL FB, P R)—
Range: 0 ~ 99%
Determines the amount of regeneration of the
right signal’s delayed repeats. The higher the
value, the greater the number of repeats. Since
the pitch shift is applied to each delayed repeat,
each successive repeat has a different pitch.
DRY LEVEL (DRY, P.S) — Range: 0 ~ 100%
Determines the level of the dry sound. A setting
of 0% results in no direct sound output. Use
this control with the Effect Mix (MIX) param-
eter above below to determine the balance
between the effect and dry sound.
HINT
Pitch Shift is capable of creating a wide
range of effects — from subtle “fattening”
of the sound to wild, special effects. To get
you started exploring some of the possibili-
ties, here are some suggested settings.
CHORUS
The detuning settings create a soft, natural chorus
effect, while the harmony settings provide a com-
pletely separate pitch, enabling two- or three-part
harmonies. With the octave and harmony settings
in particular, try increasing the Left and Right
Delay Feedback values to create interesting special
effects like stacked harmonies.
Flanger (FL)
Flanger is used to enhance the sound with modula-
tion, creating an animated, swirling motion effect.
It is effective in emphasizing the metallic sound of
a guitar. This is a stereo flanging effect that lets
you set separate left and right delay times.
SPEED — Range: 0.03 ~ 6.18 Hz
Determines the speed of the pitch modulation.
FEEDBACK (FB) — Range: 0 ~ 100%
Determines the amount of the Flanger-proc-
essed signal that is fed back to the Flanger
input. Higher values result in a stronger Flanger
sound.
DEPTH — Range: 0 ~ 100%
Determines the depth of the pitch modulation,
or how widely the pitch is varied.
Sub parameters:
EFFECT MIX (MIX) — Range: 0 ~ 100%
Determines the level of the processed signals. A
setting of 0% results in no effect output. Use
this control with the Dry Level (DRY) param-
eter below to determine the balance between the
effect and dry sound.
LEFT DELAY TIME (L TIME) —
Range: 0.1 ~ 12.0 ms
Determines the time that the signal is delayed
before applying the flanger to the left channel.
Detuning Harmony
Amp Simulation
Pitch Left
–5 ~ –25 cents
–100 ~ –1200 cents 0 cents
(–1200 = –1 octave)
Pitch Right
+5 ~ +25 cents
+100 ~ +1200 cents 0 cents
(+1200 = +1 octave)
Effect Mix 50% 50% 50%
DL TIM, P.L 10ms 10ms 0.1~2ms
DL FB, P.L 0% 0% 0%
DL TIM, P.R 10ms 10ms 0.1~2ms
DL FB, P.R 0% 0% 0%
DRY 50% 50% 100%