Filter
Top Products
82
BACKING SECTION
SONG MODE
Triggered Run
Triggered Run lets you start the currently selected
song by simply playing a note on the connected
instrument.
Operation —
1. Make sure that BACKING CONTROL has
been selected in the ASSIGNABLE Block.
2. Press and hold down the ASSIGNABLE
Block Pedal Switch.
3. While holding down the ASSIGNABLE
Block Pedal Switch, press Pedal Switch 5
(start/stop).
The instrument sound output will be cut off
temporarily, and the song playback is in
standby condition waiting for an input signal.
4. Play a note on the connected instrument. If
the input level of the GW50 has been set
appropriately and the note is not too low, the
song will start.
This initial note is muted; however, once the
song starts, the instrument sound is output
again.
❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉
❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉❉
ASSIGNABLE Block and Pedal
Switch Functions in Song Mode
Backing Control — Selecting and Playing a
Song
Operation —
1. Use the ASSIGNABLE Block Type switch to
select BACKING CONTROL. (The LED
next to the function name lights.)
Note: Chord Recall cannot be selected here. Only
Backing Control is available in the Song
mode (in playback). When pressing [SONG/
PATTERN] to select the Pattern or Song
mode, Backing Control will automatically be
selected.
2. The Pedal Switches function as shown below.
Press the appropriate Pedal Switch for the
desired function.
SONG MODE (SONG PLAYBACK)
BACKING CONTROL LED
flashes
1) While holding
this down
2) Press this
–
— Decreases
song number by
1 (only when
song is stopped).
n
— Reverse
one measure
m
— Forward one measure
— Starts/stops
song play
Holding this and pressing Pedal Switch 5 enables Triggered
Run function (see below).
+
— Increases song number by 1
(only when song is stopped).
b