Filter
Top Products
45
EFFECT SECTION
MANUAL MODE
For example, if you press [EQ] first, the
display will prompt you to press either
[CMP] or [DST]. Then, if you press [CMP],
Distortion (DST) will automatically be as-
signed to the third block. Finally, determine
the order of the last two effects by pressing
either [CHO] or [REV]; the one NOT pressed
will automatically be assigned to the fifth
block.
Repeat steps #1 and #2 above if you want to
change the order again.
HINT
For best results in connecting the various
effects, follow these guidelines:
* When using the Equalizer or Amp Simula-
tor effects with Distortion, put Distor-
tion BEFORE the EQ block.
* When using the Wah effect with Distor-
tion, put Distortion AFTER the EQ block.
Bypass Switching of Effect Blocks — GROUP
The Group function allows you to determine which
effect blocks are grouped together for one-press
effect bypassing. The effect blocks that have been
assigned here can be switched off or on all together
by pressing any one of the Pedal Switches of those
effects (when MEMORY ON/OFF is selected in the
ASSIGNABLE block). (Also see “Bypass Switching
of Effect Blocks” on page 52.) For example, if
Compressor, Distortion and Chorus have been
4. Exit this operation by pressing any of the
mode buttons ([MANUAL], [MEMORY] or
[SONG/PATTERN]).
HINT
FOR EASIER EDITING—You can easily switch back
and forth between editing main and sub
parameters in any of the effects by first selecting
the sub parameters (as done in step #1 above).
After that, you can edit the main parameters as
usual, and switch back to the sub parameters at
any time by pressing the appropriate effect selec-
tor buttons.
Utility Functions
There are five Utility functions: CONNECT,
GROUP, FOOT, MIN VOL and AUTO VOL. The
Utility functions can be executed from both the
Manual and Memory Edit modes (however, the
following explanation refers only to the Manual
mode). To exit any of these operations, press any
of the mode buttons ([MANUAL], [MEMORY]
or [SONG/PATTERN]).
Determining the Order of the Effect Blocks
— CONNECT
The Connect function allows you to determine in
what order the effect blocks will be used to proc-
ess the signal.
Operation —
1. From the Manual mode, repeatedly press the
Effect Utility switch until “CONECT” is
shown in the display.
MANUAL MODE
boxes representing the blocks in order from
left to right.) Compressor, Distortion and
Equalizer must always be among the first
three blocks; Chorus and Reverb must be the
last two.
2. Press the corresponding Effect Selector
buttons in the order that you wish the effects
to be placed. (The selected effect configura-
tion is shown graphically in the display, with