Filter
Top Products
55
EFFECT SECTION
MEMORY MODE
MEMORY JOB MODE
3. Select the destination program number with
the [–]/[+] buttons.
4. To copy the selected program to the destina-
tion number, select “GO” (press [SET-B]).
To cancel and return to Memory mode, select
“EXIT” (press [SET-A]), or press any of the
mode buttons.
CAUTION
Be careful when performing this operation,
since it automatically and irretrievably
erases the program at the destination.
Swapping One Effect Program with
Another
This is a simple renumbering operation, similar to
Copy above, that lets you switch the program
numbers of two effect programs.
Operation —
1. In the Memory mode, select one of the effect
programs to be swapped.
2. Simultaneously hold down [SHIFT] and press
[COPY/NAME] repeatedly until the Swap
display appears.
3. Select the other program number with the
[–]/[+] buttons.
4. To swap the two selected programs, select
“GO” (press [SET-B]). To cancel and return
to Memory mode, select “EXIT” (press
[SET-A]), or press any of the mode buttons.
Note: This operation changes or swaps all data, in-
cluding the program name, to the designated
program number.
Naming an Effect Program
Operation —
1. Select the effect program to be named, or use
the program currently being edited.
Note: Naming can only be done in the Memory mode. If you
are editing in the Manual mode, simultaneously press
[MANUAL] and [MEMORY], select the destination
program number with the [–]/[+] buttons, then [SET-
B] to save the effect program before naming it.
(When you save the settings in the Manual mode to
an effect program, the GW50 automatically gives it a
name, starting with the letters “MEM” and followed by
the bank number and memory number to which it has
been saved.) If you are editing in the Memory Edit
mode, press [MEMORY] to save the program and
return to the Memory mode before naming it.
2. Simultaneously hold down [SHIFT] and press
[COPY/NAME] repeatedly until the Name
display (“MEM<”) appears.
LED flashes
Cursor
LED flashes