Filter
Top Products
26
EFFECT SECTION
GUIDED TOUR (TUTORIAL)
The effect section of the GW50 has three
basic modes: Manual, Memory and
Memory Edit. In this section we’ll use the
Manual mode, since it provides a
convenient starting point for adjusting
and creating effects.
1. To select the Manual mode, press
[MANUAL].
2. Make sure that each effect block is set to its
first effect, as shown below. If it isn’t, press
the effect type switch until the LED next to
the appropriate effect is lit. (For example, the
DIST 1 LED should be lit in the Distortion
block.)
3. To start out, set the parameter knobs of the
effect blocks roughly to the positions shown
below. (The approximate suggested values of
the parameters are also given.)
CHANGING THE SOUND OF THE EFFECTS
4. Next, use the Pedal Switches to turn on only
the Chorus block. For example, if the Com-
pressor is on (its red LED will be lit), press
the Pedal Switch in the block to turn it off; if
the Chorus is off (its LED will be off), press
the Pedal Switch in the block to turn it on.
Note: The settings you’ve made in steps #2, #3 and
#4 above are only arbitrary; they make it possi-
ble for you to use and hear all of the effect
blocks. (However, the Equalizer effect is “flat”
for these settings, and cannot be heard unless
you adjust them.)
ATTACK: 7
SENSE: –24 dB
OUTPUT: 100%
OUTPUT: 50%
TONE: 0%
DRIVE: 50%
DEPTH: 50%
BRIL (Brilliance):
0 dB
SPEED: 0.60 Hz
HIGH: 0 dB
H MID: 0 dB
L MID: 0 dB
LOW: 0 dB
MIX: 25%
HIGH: 0.5
TIME:
2.0 seconds