Filter
Top Products
VOICE MODE
126
ELEMENT NUMBER SELECT - Position the
cursor over the element number field and use the
JOG, INC/DEC or the KEYPAD to choose the
desired element.
NOTE: Key Select, Element Bank Select, and Element
Number Select can be performed within any Key
Parameter function.
ALTERNATE GROUP (off, 1 ~ 8) - Position the
cursor over the Alt.Group setting field and use the
JOG, INC/DEC or the KEYPAD to assign the
element to a specific group, so that only one sound
within the group will play at a time. Assigning
certain sounds to a group will prevent unnatural
occurrences such as a closed and open hi-hat
sounding at the same time. If you assign both of
these instruments to one of the alternate groups, the
closed and open hi-hat will not sound simulta-
neously even if you play them at the same time.
GATE TIME (keyoff, 200ms, 400ms, 650ms,
1000ms, 1400ms, 2000ms, 2600ms) - Position
the cursor over the Gate Time value field and use
the JOG or INC/DEC to determine the gate time for
the assigned element. Gate Time is especially useful
for sustained sounds like a crash symbol.
DECAY (0 ~ 31) - Position the cursor over the
Decay value field and use the JOG, INC/DEC or
the KEYPAD to set the decay time for the assigned
element.
TUNE - To designate Tune parameters for each drum
element, press [F6] ( Tune ).
KEY/ELEMENT BANK/ELEMENT NUMBER
SELECT - See Assign, above.
REVERSE (off, on) - Position the cursor over the
Reverse status field and use the JOG or INC/DEC
to the make the assigned element play backwards.
TUNE (-63 ~ +63) - Position the cursor over the
Tune value field and use the JOG, INC/DEC or the
KEYPAD to adjust the fine-tuning of the assigned
element.
NOTE SHIFT (-63 ~ +63) - Position the cursor
over the Note Shift value field and use the JOG,
INC/DEC or the KEYPAD to shift the pitch of the
assigned element in semitones.
OUTPUT - To designate Output parameters for each
drum element, press [F7] ( Out ).
KEY/ELEMENT BANK/ELEMENT NUMBER
SELECT - See Assign, above.
VOLUME LEVEL (0 ~ 127) - Position the cursor
over the Volume value field and use the JOG, INC/
DEC or the KEYPAD to adjust the output volume of
the assigned element.
PAN POSITION (L31 ~ R31) - Position the cursor
over the Pan position field and use the JOG or
INC/DEC to designate the panning for the assigned
element.
SYSTEM EFFECT SEND LEVEL - To specify each
System Effect Send Level for the assigned element, from
within the Key Parameters function, press [F8]
( SysEF ).
KEY/ELEMENT BANK/ELEMENT NUMBER
SELECT - See Assign, above.
EF1/2/3 (0 ~ 127) - Position the cursor over the
EF1 , EF2 , or EF3 value field and use the JOG,
INC/DEC or the KEYPAD to set the send level for
each of the three System Effects. (NOTE: The send
levels that you assign in the Key Parameters function
is for each assigned element. To set the send levels
for the overall drum voice, see Effect, below.)
NOTE: If the Insertion Effect is set to on , each System
Effect Send level for each key element will be set to
maximum and the settings as defined in the display will
be ignored.