Filter
Top Products
GETTING STARTED
66
NOTE: Loading the
preprogrammed voice data
overwrites any other data that is
in the W5/W7 s memory, so make
sure all your important music
data is saved to floppy disk before
loading the operation.
RELOADING THE FACTORY SET VOICE DATA
If you ve initialized the Internal voice bank, or have replaced the original Internal
voices shipped with the instrument, you can reload them at any time using the Factory Set
& Demonstration disk that comes with the W5/W7.
Following is the procedure for reloading the preprogrammed data.
1. INSERT THE FACTORY SET & DEMONSTRATION DISK
Insert the disk into the disk drive. (NOTE: Make sure the label of the disk is
facing upward, and be sure to put the end with the sliding disk shutter into the
disk drive slot first.)
2. ENTER DISK MODE
Press the DISK button in the Mode section. The screen will display the various
Disk Mode functions.
3. CHOOSE LOAD FROM DISK
Press the function key [F4] located directly beneath the word Load displayed at
the bottom of the screen. The screen will display the various file types.
4. CHOOSE VOICE
Press the function key [F6] ( Voice ).
5. LOAD THE VOICES
Press ENTER to load the voices into the W5/W7.
6. EJECT THE DISK
When you re finished with the voice loading operation, press the eject button on
the disk drive to eject the disk. Store the disk in a safe place in case you need to
reload the voice data again in the future.