Filter
Top Products
17
Model LR16 [Before using the unit]
Using the supplied power cord, con-
nect the [AC IN] connector on the rear
panel of the main unit and the AC
outlet.
[POWER] switch
AC outlet
Press down the [POWER] switch on the
rear panel of the main unit to turn on
the power.
After a while, the LR16 normally starts
up and the display on the recorder
unit shows "<No project>" (indicating
that nothing is recorded on the
recorder's hard disk).
For details about recording, see "Mixer
function" on page 33 and "Recorder
function" on page 43.
To turn on or off the LR16 and peripheral devices which are connected to the LR16,
follow the proper procedures described below.
Connecting the power cord
Turning on the power
<Note>:
Use only the supplied power
cord.
Preparation of power supply
Procedures of turning on the power after connecting peripheral devices
<Note>:
Before turning on or off the LR16 and peripheral devices which are connected to
the LR16, make sure that the channel faders and monitor gain control of the LR16, as
well as the volume control of an monitor amplifier (or powered monitor speaker), are set
to minimum. Otherwise, a loud sound may be produced suddenly that may damage the
speaker or your hearing.
(1) Turn on the devices connected to the [INPUT] connectors to the LR16.
(2) Turn on the LR16.
(3) Turn on the monitor amplifier (or powered monitor speaker).
Procedures of turning off the power after connecting peripheral devices
(1) Turn off the monitor amplifier (or powered monitor speaker).
(2) Turn off the LR16.
(3) Turn off the devices connected to the [INPUT] connectors to the LR16.