Filter
Top Products
49
Model LR16 [Recorder functions / Recording/playback]
<Memo>: You can monitor an input sig-
nal via headphones or monitor speakers
when the solo function is engaged. The
monitor level can be controlled by using
the [MONITOR] and [PHONES] controls
(the latter only affects headphone moni-
toring).
Adjusting the channel output levels sent to
the stereo buss
After adjusting the input level of each channel,
you can tailor the channel signal and send it to
the stereo buss via the pan pot and channel
fader. (This determines the sound output from
the main speaker in live performance.)
Before executing the following procedure, make
sure that the "ST" indicator is lit and the [SOLO]
indicator is unlit in the [MONITOR SELECT] sec-
tion.
(1) Set the [ST] switch on each of mixer
channels 1 through 16 to "ON" (
). and
raise the [STEREO] fader to the "0"
position.
In this condition, by raising the channel
fader, each channel signal is sent to the
stereo L/R buss.
ON ( )
STEREO
Each channel fader adjusts the channel
output level sent to the stereo buss.
The "LR" meters on the display shows the
stereo L and R buss output levels, while the
channel meters shows the channel input
levels.
Input levels of channels 1 through 16
Stereo L and R buss output levels
<Memo>: You can use the equalizer and
the internal effects for each mixer chan-
nel signal. See "Mixer function" on page
33 for details about the equalizer and the
internal effects.
The total output levels of the stereo L and R
buss (= the input levels for stereo mix re-
cording) can be adjusted using the [STE-
REO] fader.
Recording
<Note>:
The maximum file size for each record-
ing file is 4 GB. The LR16 automatically stops
when the file size reaches 4 GB or when there is
no recordable space left.
<Memo>: If you press the [NEW PRJ. REC]
key in the mixer section, the recording
starts in new project mode regardless of
the on/off setting of the [NEW PROJECT]
key.
(1) Press the [NEW PROJECT] key in the
recorder section to turn on the key.
Lit
Now you have completed all the adjustment
and are ready for both PA and recording of
the actual live performance.
Flashing
(2) Press the [PLAY] key while holding down
the [RECORD] key (or press the [NEW PRJ.
REC] key) to start recording.
1 ~ 16
Lit
In this condition, you can monitor the stereo
buss signal via headphones or monitor speak-
ers. The monitor level can be controlled by us-
ing the [MONITOR] and [PHONES] controls (the
latter only affects headphone monitoring).
(2) Raise each of the channel faders
appropriately while rehearsing.