Filter
Top Products
82
Model LR16 [Recorder function / Other functions]
(3) Use the [MENU] dial to highlight "Default
frame" and press the [ENTER] key.
The current frame setting starts flashing (by
default, "25FPS" is selected).
(4) Use the [MENU] dial to select the desired
frame rate and press the [ENTER] key.
You can select between "25FPS" and
"30FPS".
(5) Press the [STOP] key to exit the MENU
mode.
MIDI synchronization
MIDI (Musical Instrument Digital Interface)
is an industry-standard protocol which en-
ables electronic musical instruments, comput-
ers, and other equipment to communicate,
control, and synchronize with each other.
<MIDI connection>
To send MIDI message from the LR16 to exter-
nal MIDI equipment, connect the [MIDI OUT]
port of the LR16 to the [MIDI IN] port of exter-
nal MIDI equipment using a MIDI cable.
INSERT
INSERTINSERTINSERTINSERTINSERTINSERTINSERT
INPUT
AUX SEND (-2dBu)
EFF SEND (-2dBu)
GROUP (+4dBu)
R STEREO OUT (+4dBu) L
ST MIX OUT (-10dBV)
USB
MIDI OUT
FOOT SW CONTROLLERPANEL LOCK
LOCK
PHANTOM
POWER
External MIDI equipment
MIDI IN
<Note>:
The LR16 can be a master but can-
not be a slave.
<MIDI message supported by the LR16>
The [MIDI OUT] port of the LR16 sends MTC
(MIDI Time Code) message which allows syn-
chronization between the LR16 and external
MIDI equipment. The frame rate of MTC is set
to 25 fps by default, however, you can also set
it to 30 fps (see the right column on this page
for details about how to set the frame rate).
<Memo>: This manual contains the MIDI
implementation chart of the LR16 on page
86. When you use MIDI equipment with
the LR16, check the MIDI implementation
charts of the LR16 and MIDI equipment.
(1) Press the [ENTER] key to bring up the
MENU screen.
When you bring up the MENU screen for
the first time, "Mark point" is highlighted.
(2) Use the [MENU] dial to highlight "System"
and press the [ENTER] key.
The display now shows the system menu
screen.
• Setting frame rate
<Note>:
It is recommended to set the frame
rate before you make recording in the new
project mode or you create a new project
using the "Project" menu in the MENU mode.
<Memo>: If you initialize the system
memory via the "Sys default memory"
menu item of the "System" menu, the
frame rate reverts back to the default
setting ("25FPS").