Filter
Top Products
59
Model LR16 [Recorder functions / Memory play]
6) After you complete assignment, press the
[EXIT/NO] key.
The display returns to the memory play
setup screen, where "Sound file" is
highlighted.
• Selecting a channel pair for memory play
Using the "Assign/MemPlay" menu item, you
can select a mixer channel pair to which the
memory play signal is assigned. By default,
No channels are selected ("-/-" is shown).
In the following description, it is assumed that
the memory play setup screen is shown.
7) Use the [MENU] dial to highlight "Assign/
MemPlay" and press the [ENTER] key.
You can select an odd/even channel pair
from 1/2 to 17/18, or -/-.
<Note>:
You cannot assign the memory
play and the Sub in signals to the same
channel pair. If you attempt to assign
the memory play signal to the same
channel pair as the Sub in signal, the
following message is shown for a few
seconds.
<Note>:
To enable the memory play function,
you have to select a channel pair (other than
"-/-").
<Note>:
If you attempt to assign the
memory play signal to a channel whose
corresponding track is currently record-
armed, the following message is shown
for a few seconds.
8) Use the [MENU] dial to select a desired
channel pair and press the [ENTER] key.
The memory play signal is now assigned to
the selected channel pairs.
If necessary, select the memory play mode
as described below.
• Selecting the memory play mode
You can select the memory play mode be-
tween "ONCE" and "REPEAT". By default, it is
set to "ONCE". When you perform memory
play in this mode, the LR16 plays back a ste-
reo mix file once and stops.
The following describes how to select the
memory play mode. It is assumed that the
memory play setup screen is shown.
9) Use the [MENU] dial to highlight "Play
mode" and press the [ENTER] key.
The current setting flashes. You can select
between "ONCE" and “REPEAT".
If you want to assign the memory play sig-
nal to the channel pair to which the Sub in
signal is currently assigned, change the as-
signment of the Sub in signal in the follow-
ing steps before selecting the channel pair
for the memory play signal.
1. Use the [MENU] dial to highlight "SubIn" and
press the [ENTER] key.
2. Use the [MENU] dial to select a desired
channel pair and press the [ENTER] key.