Filter
Top Products
53
Model LR16 [Recorder functions / Recording/playback]
Starting mixdown recording
(1) Press the [ST MIX] key in the recorder
section to turn it on.
"LR" starts flashing on the display and the
recordable remaining time is shown.
(2) Press the [PLAY] key while holding down the
[RECORD] key to start mixdown recording.
<Memo>: The mixed down file (stereo WAV file)
is stored to the "2mix" folder in the current
project.
PROJ001
2mix
PROJ001-01
take001trk01 take001trk02
take001trk03
take001trk04
take001trk16
(1) Set the [SOURCE] switch on each of mixer
channels 1 through 16 to "TRK" (
).
The corresponding recorder track output
is selected as the channel source of each
channel.
(2) Turn off the [NEW PROJECT] key in the
recorder section.
(3) Change the destination channels of Sub In
from “15/16” (default) to “-/-” (no channels are
assigned).
See page 79 for details about how to assign
the destination channels of Sub In.
Adjusting level and sound of each track
Preparation
(1) Set the [ST] switch on each of mixer
channels 1 through 16 to ON (
).
Each input signal is routed to the stereo
L/R buss via the input fader.
(2) Raise the [STEREO] fader to the "0" position.
(3) Press the [PLAY] key in the recorder or mixer
section to start playback of the project.
(4) Use the channel fader on each mixer channel
to adjust the track level.
The display shows the levels of tracks 1
through 16 as well as the stereo L/R buss.
(5) Use the [STEREO] fader to adjust the total
level of the stereo L/R buss.
You can monitor the stereo L/R buss by
raising the [PHONES] and [MONITOR]
controls.
(6) After finishing adjustment, press the [STOP]
key in the recorder or mixer section to stop
the recorder.
If you press the [STOP] key in the recorder
section, the recorder stops at the recording
end position (REC END).
If you press the [STOP] key in the mixer
section, the recorder skips back to the
beginning of the project (ABS 0) and stops.
You can also control each track sound us-
ing the equalizer on each channel and the
internal effects processor, as well as set pan.
For details about the mixer function, see
"Mixer function" on page 33.
<Note>:
Do not press the [NEW PRJ. REC]
key in the mixer section.
(3) After finishing mixdown recording, press the
[STOP] key in the recorder or mixer section
to stop the recorder.
If you press the [STOP] key in the recorder
section, the recorder stops at the recording
end position (REC END).
If you press the [STOP] key in the mixer
section, the recorder skips back to the
beginning of the project (ABS 0) and stops.
You can copy the mixed down file to a per-
sonal computer by directly connecting the com-
puter to the LR16 or via a USB memory stick.
(See page 73 for details about how to transfer
to a computer. See page 67 for details about
how to copy to a USB memory stick.)
<Note>:
You cannot play back a mixed down
file directly, however, you can play it back
using the memory play function (see page
57).