Filter
Top Products
Model LR16 [Names and functions]
23
(7) [POST/PRE] switch
Selects post-fader or pre-fader feed of the AUX 1 buss (each press of
the switch alternates the selection).
When the switch is set to the up ( ) position, post-fader is
selected. When the switch is set to the down ( ) position,
pre-fader is selected.
(8) [AUX 1] control
Adjusts the signal level fed to the AUX 1 buss from each input
channel. The post-fader or pre-fader signal selected by the [POST/
PRE] switch is fed to the AUX 1 buss.
(9) [AUX 2 (PRE)] control
Adjusts the signal level fed to the AUX 2 buss from each input
channel. The pre-fader signal is fed to the AUX 2 buss.
(10) [AUX 3 (POST)] control
Adjusts the signal level fed to the AUX 3 buss from each input
channel. The post-fader signal is fed to the AUX 3 buss.
(11) [EFF] send control
Adjusts the signal level fed to the EFF buss from each input channel.
The post-fader signal is fed to the EFF buss, therefore, fader setting
affects the signal sent to the [EFF] buss.
(12) [PAN] control
Determines the signal balance between the left and right of the
stereo busses or odd and even busses of group buss pairs 1-2 and
3-4.
Rotating the control to the right (clockwise) increases the amount of
the signal from the channel going to the right of the stereo buss,
while decreases the amount of the signal going to the left of the
stereo buss.
Rotating the control to the left (counterclockwise) increases the
amount of the signal from the channel going to the left of the stereo
buss, while decreases the amount of the signal going to the right of
the stereo buss.
(13) [MUTE] switch
Switches the mute function on or off. When the switch is set to the
down position ( ), the post fader signal of the channel is muted.
(14) [ST/1-2/3-4] assign switches
Assign or deassign the input channel signal to the corresponding
buss pairs (Stereo, groups 1-2 or groups 3-4). When the switch is set
to the down position ( ), the signal is assigned to the
corresponding buss pair. You can assign the signal to more than one
buss pair at the same time.
(15) [SOLO] switch
Switches the solo function on or off. When the switch is set to the
down position ( ), the pre-fader signal can be monitored via the
solo buss. When the [SOLO] switch on any input channel is set to
ON, the [SOLO] indicator on the monitor section flashes.
(16) Channel fader
Adjusts the output level of the input channel.
1
3
4
5
6
7
9
10
11
12
13
14
15
16
2
8