Filter
Top Products
HUAWEI MG323 GSM M2M Module
AT Command Interface Specification Commands for Short Messages
Issue 02 (2010-11-23)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
169
z
0 (default value): buffers the short message notification on the ME. If the buffer
of the ME is full, the new notification overwrites the oldest one.
z
1: sends the short message notification directly to the TE. When the notification
fails to be sent (for example, in online data mode), the notification is discarded.
z
2: sends the short message notification and the short message status report
directly to the TE. When the notification fails to be sent (for example, in online
data mode), the notification is buffered on the ME. When the buffered notification
can be sent, it is sent to the TE at a time.
<mt>: integer, which sets the rules for storing and notifying the received short
messages.
z
0 (default value): No SMS-DELIVER indications are sent to the TE.
z
Three methods of storing and notifying new short messages are as follows:
z
1: stores the SMS-DELIVER on the MT and sends a storage location notification
to the TE. +CMTI: <mem>,<index>
z
2: does not store the SMS-DELIVER on the MT and sends the SMS-DELIVERS
directly to the TE.
PDU mode: +CMT: [<reserved>],<length><CR><LF><pdu>
z
3: stores the SMS-DELIVER on the MT and does not send the SMS-DELIVER
notification to the TE (not supported currently).
<bm>: integer, which sets the rules for storing and notifying the received cell
broadcast messages (CBMs).
z
0: No CBM is reported to the TE (default value).
z
2: New CBMs are sent directly to the TE through unsolicited reporting:
PDU mode: +CBM: <length><CR><LF><pdu>
<ds>: integer, which sets the return receipt of short messages.
z
0: does not send the return receipt of short messages to the TE.
z
1: does not store the return receipt of short messages on the MT and sends it
directly to the TE.
PDU mode: +CDS: <length><CR><LF><pdu>
<bfr>: integer, which sets the buffer processing mode when the <mode>=0 mode is
changed to the <mode>=1-2 mode.
z
0: sends the buffered URCs to the TE at a time when the <mode>=0 mode is
changed to the <mode>=1-2 mode (default value).
z
1: clears the buffered URCs when the <mode>=0 mode is changed to the
<mode>=1-2 mode.