Filter
Top Products
HUAWEI MG323 GSM M2M Module
AT Command Interface Specification Commands for Status Control
Issue 02 (2010-11-23)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
29
<disp>: integer; enables display event reporting, which is not supported currently.
0 Reports the event.
<ind>: integer; indicates event reporting.
z
0 (default value): disables event reporting.
z
1: enables event reporting; +CIEV:<ind>,<value>, in which <ind> indicates the
event of the indicator, which is a character string.
z
2: enables event reporting; +CIEV: <ind>,<value>, in which all events occur
directly between the TE and TA.
<bfr>: integer; clears the buffer.
0 Clears the buffer.
3.1.2 Reading the Current Settings for Event Reporting
Read
command
AT+CMER?
Function
Reads the current settings for event reporting.
Response
<CR><LF>+CMER: <mode>,<keyp>,<disp>,<ind>,<bfr><CR><LF>
<CR><LF>OK<CR><LF>
3.1.3 Setting the Event Reporting Mode
Write
command
AT+CMER=[<mode>[,<keyp>[,<disp>[,<ind>[,<bfr>]]]]]
Function
Sets the event reporting mode.
Response
z
In case of successful execution: <CR><LF>OK<CR><LF>
z
In case of an error: <CR><LF>ERROR<CR><LF>
z
In case of an error related to the MT: <CR><LF>+CME ERROR:
<err><CR><LF>
Note:
If no parameters of this command are set, AT+CMER= considers the previously set values
valid for various parameters.
3.2 AT+CIND - Command for Controlling Indication
Events
The AT+CIND command controls the mode of reporting indication events for certain
functions, including battery power level, signal strength, service availability, unread
short message indicator, and full short message storage.