Filter
Top Products
HUAWEI MG323 GSM M2M Module
AT Command Interface Specification Commands for Call Control
Issue 02 (2010-11-23)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
72
7.16.2 Reading the Settings of the CLIP Service
Read
command
AT+CLIP?
Function
Reads the settings of the CLIP service.
Response
z
In case of successful execution:<CR><LF>+CLIP:
<n>,<m><CR><LF>
<CR><LF>OK<CR><LF>
z
In case of an error: <CR><LF>ERROR<CR><LF>
Parameter description
<m>: integer; sets whether the CLIP service is provisioned on the network.
z
0: indicates that the CLIP is not provisioned.
z
1: indicates that the CLIP is provisioned.
z
2: unkown (due to interworking problems or limitations of originating network).
7.16.3 Setting the CLIP
Write
command
AT+CLIP=[<n>]
Function
Enables or disables the CLIP service.
Response
z
In case of successful execution: <CR><LF>OK<CR><LF>
z
In case of an error: <CR><LF>ERROR<CR><LF>
z
In case of an error related to the MT: <CR><LF> +CME
ERROR: <err><CR><LF>
Note:
AT+CLIP= is equivalent to AT+CLIP=0.
7.16.4 +CLIP - Command for Unsolicitedly Reporting the CLI
URC <CR><LF>+CLIP:
<number>,<type>[,<subaddr>,<satype>[,[<alpha>][,<CLI
validity>]]]<CR><LF>
Parameter description
<number>: character type, which indicates the telephone number.
<type>: integer type, which indicates the telephone number in character type.
z
145: international number
z
129: other number