Filter
Top Products
HUAWEI MG323 GSM M2M Module
AT Command Interface Specification Commands for Status Control
Issue 02 (2010-11-23)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
31
<indDescr> <indValue>
0: registers with the home network or does not
register with any network.
“roam”: roaming indicator.
1: registers with the roaming network.
0: The short message storage media is not full. “smsfull”: short message
storage full indicator.
1: The short message storage media is full.
0: ≤ -112 dBm
1–4: The strength interval is 15 dBm.
5: ≥ -51 dBm
“rssi”: receive signal strength
indicator.
99: unknown or unmeasurable.
3.2.2 Reading the Current Indication Status
Read
command
AT+CIND?
Function
Reads the current indication status.
Response
<CR><LF>+CIND: <indValue>[,<indValue>[, …]] <CR><LF>
<CR><LF>OK<CR><LF>
3.2.3 Setting Whether to Report Indication Events
Write
command
AT+CIND=<mode>[,<mode>[,<mode>...]]
Function
Sets whether to report indication events.
Response
z
In case of successful execution: <CR><LF>OK<CR><LF>
z
In case of an error: <CR><LF>ERROR<CR><LF>
z
In case of an error related to the MT: <CR><LF> +CME ERROR:
<err><CR><LF>
Parameter description
<mode>: integer. This parameter controls whether to report a single indication event.
0: deregisters indication event and disables event reporting.
1 (default value): registers indication event and enables event reporting.