Filter
Top Products
HUAWEI MG323 GSM M2M Module
AT Command Interface Specification Commands for Status Control
Issue 02 (2010-11-23)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
33
<indDescr>: string; Table 3-2 describes the values of the parameter.
Table 3-2 Values of the <indDescr> and <indValue> parameters
<indDescr> <indValue>
0: has not been connected to any charger.
1: has been connected to a charger.
2: being charged.
3: The charge process is complete.
4: The charge process is interrupted due to an
error.
“battchg”: battery power level
indicator. Currently, only the
value 5 is supported.
5: unknown.
0: ≤ -113 dBm
1: -111 dBm
2–30: -109 dBm to -53 dBm
31: ≥ -51 dBm
“signal”: receive signal bit error
rate indicator. Currently, only the
value 99 is supported.
99: unknown.
0: has not been registered with any network. “service”: network service status
indicator.
1: has been registered with the home network.
When “roam”=1, the MT has been registered with
another network.
0: without ring. “sounder”: audio status indicator,
which indicates an event with
ring. Currently, only the value 0
is supported.
1: with ring.
0: without unread short message. “message”: unread short
message indicator.
1: with unread short message.
0: without conversation. “call”: conversation status
indicator.
1: ongoing conversation or conversation hold.
0: registers with the home network or does not
register with any network.
“roam”: roaming indicator.
1: registers with the roaming network.
0: The short message storage media is not full. “smsfull”: short message storage
full indicator.
1: The short message storage media is full.
0: ≤ -112 dBm
1–4: The strength interval is 15 dBm.
“rssi”: receive signal strength
indicator.
5: ≥ -51 dBm