Filter
Top Products
HUAWEI MG323 GSM M2M Module
AT Command Interface Specification Contents
Issue 02 (2010-11-23)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
v
7.16.4 +CLIP - Command for Unsolicitedly Reporting the CLI....................................................... 72
7.17 RING – Command for Unsolicitedly Reporting Incoming Calls.................................................... 73
7.18 +CRING – Command for Unsolicitedly Reporting Incoming Calls............................................... 73
8 Commands for Network Services ............................................................................................74
8.1 AT+COPN - Command for Querying the Operator Name.............................................................. 74
8.1.1 Checking Whether This Command Is Supported.................................................................. 74
8.1.2 Reading the List of Operators ............................................................................................... 75
8.1.3 Examples............................................................................................................................... 75
8.2 AT+COPS - Command for Selecting Operators............................................................................. 75
8.2.1 Checking the Current Available Network and Operator Information ..................................... 76
8.2.2 Reading the Currently Registered Network and Operator Information ................................. 77
8.2.3 Setting the Current Operator Information.............................................................................. 77
8.2.4 Examples............................................................................................................................... 77
8.3 AT+CREG - Command for Querying Network Registration ........................................................... 78
8.3.1 Checking the Parameter Range Supported by This Command............................................ 78
8.3.2 Querying the Current Status of Network Registration ........................................................... 79
8.3.3 Setting the Status of Network Registration............................................................................ 79
8.3.4 +CREG – Command for Unsolicitedly Reporting the Network Registration Status .............. 80
8.3.5 Examples............................................................................................................................... 80
8.4 AT+CSQ - Command for Querying the Signal Quality ................................................................... 80
8.4.1 Checking the Parameter Range Supported by This Command............................................ 81
8.4.2 Querying the Current Signal Quality...................................................................................... 82
8.4.3 Examples............................................................................................................................... 82
8.5 AT^SMONC - Command for Querying the Cell Information........................................................... 82
8.5.1 Checking Whether This Command Is Available .................................................................... 83
8.5.2 Querying the Cell Information................................................................................................ 83
8.5.3 Examples............................................................................................................................... 84
8.6 AT^SMOND - Command for Querying the Cell Information (Including Neighbor Cells) ................ 84
8.6.1 Checking Whether This Command Is Available .................................................................... 84
8.6.2 Querying the Cell Information................................................................................................ 85
8.6.3 Examples............................................................................................................................... 86
8.7 AT^MONI - Command for Querying the Cell Information in Idle and Dedicated Modes................ 86
8.7.1 Checking the Parameter Range Supported by This Command............................................ 86
8.7.2 Obtaining the Information About the Serving Cell or Dedicated Cells................................... 89
8.7.3 Periodically Obtaining the Information About the Serving Cell or Dedicated Cells. .............. 89
8.7.4 Examples............................................................................................................................... 90
8.8 AT^MONP - Command for Monitoring Idle Neighbor Cells ............................................................ 91
8.8.1 Checking the Parameter Range Supported by This Command............................................ 92
8.8.2 Obtaining the Monitoring Information About Neighbor Cells ................................................. 93
8.8.3 Periodically Obtaining the Monitoring Information About Neighbor Cells.............................. 94
8.8.4 Examples............................................................................................................................... 94