Filter
Top Products
Arpeggiator settings
102
Other examples of creating a user
arpeggio pattern
Melody pattern
1. Set “Step (Step No.)” to 01, and press the [0]
button.
Set “Ptch (Pitch Offset)” to +00.
2. Set “Step (Step No.)” to 02, and press the [0]
button.
Set “Ptch (Pitch Offset)” to +10.
3. Set “Step (Step No.)” to 03, and press the [0]
button.
Set “Ptch (Pitch Offset)” to +00.
4. Set “Step (Step No.)” to 04, and press the [0]
button.
Set “Ptch (Pitch Offset)” to +00.
5. Set “Step (Step No.)” to 05, and press the [0]
button.
Set “Ptch (Pitch Offset)” to +12.
6. For “Step (Step No.)” 06, do not enter a tone.
7. Set “Step (Step No.)” to 07, and press the [0]
button.
Set “Ptch (Pitch Offset)” to +00.
8. Set “Step (Step No.)” to 08, and press the [0]
button.
Set “Ptch (Pitch Offset)” to –02.
Chordal pattern
1. Set “Step (Step No.)” to 01, and press the [0]
button.
Set “Gt (Gate)” to LGT.
2. For “Step (Step No.)” 02, do not enter a tone.
3. Set “Step (Step No.)” to 03, and press the [1],
[2], [3], [4] buttons.
4. Set “Step (Step No.)” to 04, and press the [1],
[2], [3], [4] buttons.
5. For “Step (Step No.)” 05, do not enter a tone.
6. Set “Step (Step No.)” to 06, and press the [1],
[2], [3], [4] buttons. Set “Gt (Gate)” to LGT.
7. For “Step (Step No.)” 07, do not enter a tone.
8. Set “Step (Step No.)” to 08, and press the [1],
[2], [3], [4] buttons.
Note: To simulate the timing nuances of a
strummed guitar chord, select “Flam.” In
Program mode, select an acoustic guitar
program, and choose the user arpeggio pattern
that you created here. In the Setup page of
PROG 7: Ed–Arp/Ctrls, Setup, set “Gate” to
Step.
Then return to the GLOBAL 5: Arp.Pattern,
Edit page. For odd-numbered steps, set “Flam”
to a positive (+) value. For even-numbered
steps, set “Flam” to a negative (–) value.
Drum pattern
You can use the arpeggiator to play a rhythm pat-
tern by using “Fixed Note” with a drum program.
1. Select a drum kit program.
For this example, select preset program A020:
Standard Kit 3.
2. Select the GLOBAL 5: Arp.Pattern, Setup page,
and set the parameters.
Check “Fixed Note.” If this is checked, tones
will always sound at the specified pitch.
If you set “Mode (Fixed Note Mode)” to
Trigger All Tones, playing a single note will
cause all Tones to sound. If you set “Mode
(Fixed Note Mode)” to Trigger As Played, the
notes you play will determine how Tones are
sounded.