Filter
Top Products
23
Quick StartIntroductionSetupProgram
Combination
MultiEffectGlobalArpeggiatorDrum Kit
External control
Other functions
Appendices
Setup
Turning the power on/off
Connecting the AC adapter
You must use only the included AC adapter.
Using any other AC adapter may cause
malfunctions.
Note: Make sure that the X50’s power switch is set
to STANDBY (the outward position).
1. Connect the plug of the included AC adapter to
the power connector on the X50’s rear panel.
2. Connect the power cable to the AC adapter.
3. Plug the power cable into an AC outlet.
4. To prevent the plug from being pulled out
accidentally, wrap the AC adapter cable
through the cable hook located on the rear of
the X50. Be careful not to bend the base of the
plug unnecessarily.
Turning the power on
1. Lower the X50’s [VOLUME] slider.
If you have connected powered monitor
speakers or a stereo amp, turn down the
volume of these devices.
2. Press the rear panel Power switch to turn on
the power.
The display will show the model name,
software version.
(The following graphic shows the factory-set
display. The version number is subject to
change without notice.)
3. Turn on your powered monitors or stereo amp.
4. Raise the X50’s [VOLUME] slider to an
appropriate position, and adjust the volume of
your powered monitor speakers or stereo amp.
Note: The state of X50 when the power is turned
on will depend on the setting of “Power On
Mode” (GLOBAL 0: System, Preference page).
(☞p.88)
Connecting the AC adapter
AC adapter
Plug into an AC
outlet
3 Power cable
1 Power connector
Power switch
Be careful not to
bend this portion
excessively when you
wrap the cable
through the cable
hook.
4 Cable hook
2