Filter
Top Products
Using Controllers
59
Quick StartIntroductionSetupProgram
Combination
is received, the program will change for timbres
whose “Status” is INT. However, program
changes for timbres are affected by the COMBI 3:
Ed–MIDI Filter1, -1 page “Program Change” set-
ting.
The “Status” setting is located in the COMBI 2:
Ed–Track Param, MIDI page, and the “Program
Change” setting is located in the COMBI 3: Ed–
MIDI Filter1, -1 page.
The result of receiving a program change on the
global MIDI channel will depend on the GLOBAL
1: MIDI “Combi (Combination Change)” setting.
Using Controllers
Just as in Program mode, you can use controllers
such as the [MOD] wheel, pitch bend wheel,
[SW1][SW2], and REALTIME CONTROLS [1]–[4]
to add a broad range of expression to your playing
in Combination mode.
These controls let you modify the tone, pitch, vol-
ume, effects, etc. in realtime while you play.
For more details, see “Using Controllers” (☞p.59).
Sending MIDI information from the
various controllers
When you select a combination on X50, a MIDI
program change for the selected combination
number will be transmitted on the global MIDI
channel. At the same time, bank select, program
change, and volume (CC#7) messages will be
transmitted on the MIDI channel specified for
each timbre that is set to “Status” of EXT or EX2.
However, these messages will not be transmitted
for timbres that are set to the same MIDI channel
as the global MIDI channel. In this case, EX2 tim-
bres will show the “Program Select” Bank as “–”,
and will transmit the bank number that was speci-
fied in “Bank (EX2) MSB”and “Bank (EX2) LSB”
(2–1a).
MIDI messages transmitted when you operate X50
are transmitted on the global MIDI channel. At the
same time, timbres whose “Status” is EXT or EX2
will transmit the same messages on their own
MIDI channel.
For details on the MIDI messages transmitted
when you operate an X50 controller, and on the
AMS (Alternate Modulation Source) and DMS
(Dynamic Modulation Source) corresponding to
the MIDI messages, see “MIDI transmission when
the X50/microX’s controllers are operated” (☞PG
p.166).