116
Chapter 8 EZ Routing
Setting Up for Mixing Using Step
Editing
Select this when you want to adjust the balance of each track,
or to mix your song to an external two-track recorder. Select
this to use the Input Mixer during mixdown to mix external
sources along with your 18 tracks to the VS-1824’s stereo
MASTER mix outputs. If you want to cancel the settings
procedure before completing it, press [F6 (EXIT)] at any time.
1. Press [EZ ROUTING].
The EZ Routing icon appears in the display.
2. Press [F5 (Exec)].
If “Exec” does not appear in the display above [F5], press
[PAGE] until you see “Exec,” and then press [F5 (Exec)].
fig.02-18
3. Press [F2 (Mix)].
4. Specify which sources are to be output to the MIX bus.
Press the Input SELECT buttons and the Track SELECT
buttons for all mixer channels you want to include. Use
[] and [ ] to move the cursor and the TIME/
VALUE dial to select the V-Track you want to play back.
fig.02-25
5. Press [F2 (STEP →)].
6. Only the sources—Input Mixer Channels and Track
Mixer Channels—you specified during Step 4 will be
shown. Use [ ], [ ], [ ], and [ ] to move
the cursor and the TIME/VALUE dial to adjust each of
the values.
fig.02-26
7. Press [F2 (STEP →)]. You can return to the previous
screen by pressing [F1 (STEP ←)].
8. Make the settings for the effects. Use [ ], [ ],
[ ], and [ ] to move the cursor and the
TIME/VALUE dial to adjust each of the values. Press
[F3 (FX A)] to make settings to EFFECT A (FX1/2); press
[F4 (FX B)] to make settings to EFFECT B (FX3/4).
fig.02-27
9. Press [F2 (STEP →)]. You can return to the previous
screen by pressing [F1 (STEP ←)].
Track assigned to the MIX bus
Source assigned to the MIX bus
Source
Track
V-Track
Cursor
Pan
Level
Input Channel Track Channel
Effect
Switch
Send
Level
Send
Pan
Cursor
