75
Chapter 5 Using the Digital Mixer
Chapter 5
Changing settings of the Track
Mixer Buttons and Faders
(Fader Mode)
You can switch the panel buttons and faders that are used to
affect each Track Mixer channel.
1. Press [PLAY (DISPLAY)].
2. Hold [SHIFT] and press [F5 (SYSTEM)].
The System menu icon appears in the display.
If the System menu does not appear, press [F6 (EXIT)].
3. Press [F1 (SYSPM)].
If “SYSPM” does not appear above [F1], press [PAGE]
until “SYSPM” appears, then press [F1 (SYSPM)].
4. Using [ ], [ ], [ ], and [ ], select “Fader
Mode.” If “Fader Mode” does not appear in the display,
press [F1 (Prm 1)].
Fader Mode
Used for specifying the correspondence or assignment of
panel buttons and faders to each of the Track Mixer channels.
VS-1824: Assignments are as indicated on the panel.
VS-1880: Assignments are according to the overlay
sheet provided with the workstation.
5. Press [PLAY (DISPLAY)] to return to the Playlist display.
Mixer Routing
Sources Assigned to Tracks
In a newly created song, inputs are assigned to tracks as
shown below. This is the default mixer routing.
fig.03-05a
Using the STATUS and SELECT buttons, it is possible to set
up almost any type of routing. To determine the source(s)
assigned to a track for recording, use the following procedure.
When “VS-1880” is selected as the fader mode (p. 75), inputs
are assigned to tracks as shown below.
