135
Chapter 9 Automix
Chapter 9
Smooth Data Transitions
(Gradation)
This operation creates Automix data that smoothly connects
the first Automix marker in the specified area with the last
marker.
fig.4-12.e
Editing of the Automix data cannot be cancelled by the Undo
function.
1. Press [PLAY (DISPLAY)].
2. Hold down [SHIFT] and press [F6 (UTIL)].
3. Press [PAGE] so that [F5] indicates “A.Mix,” and then
press [F5 (A.Mix)].
4. Press [F2 (Micro)].
5. Press [PAGE] so that [F1] indicates “In.”
fig.4-03
6. Make sure that the cursor is located at “Edit Target,” and
use the TIME/VALUE dial to select the type of Automix
data to which you wish to apply the Gradation
operation.
7. Use [ ] and [ ] to move the cursor to the first
marker of the Automix data to which you wish to apply
the Gradation operation, and press [F1 (In)].
8. Use [ ] and [ ] to move the cursor to the last
marker of the Automix data to which you wish to apply
the Gradation operation, and press [F1 (Out)].
checkmarks will be added to the range selected for
Gradation.
fig.4-04.e
You can turn the TIME/VALUE dial to modify the Automix
setting value at the cursor location. If you wish to re-select
the type of Automix data that will be edited, press [ ].
9. Press [F4 (Grad)].
10. Use [ ], [ ], [ ], and [ ] to move the
cursor. Turn the TIME/VALUE dial to set each
parameter.
fig.4-16
Value
Adjust the beginning (In:) and end (Out:) of the Gradation
area.
0M1 M7
Time
Gradation area
0M1 M7
Time
Gradation area
Check marks
