40
Chapter 3 Playback Operations
Function Buttons
(While on the Playlist Display)
In the Playlist display, the function buttons perform as follows.
* If “ZOOM+” does not appear above F1, press [PAGE] until it
does.
[F1 (ZOOM+)]:
This enlarges, in three stages, the display of the tracks. When
a waveform is displayed, this will make it appear taller.
fig.12-10
[F2 (ZOOM-)]:
This reduces, in three stages, the display of the tracks. When
a waveform is displayed, this will make it appear shorter.
fig.12-11
[F3 (← →)]:
This stretches the timeline in four stages. When a waveform
is displayed, this laterally stretches out the waveform.
fig.12-12
[F4 (→ ←)]:
This shrinks the timeline in four stages. If a waveform is
displayed, this will squeeze the waveform.
fig.12-13
[F5 (WAVE)]: This displays the audio waveform for the
corresponding track as selected using the [ ] and [ ]
cursors. Press [F5 (WAVE)] once to display the waveform.
Press [F5 (WAVE)] again to remove the waveform. (Make
sure that the track you have selected contains audio.)
fig.12-14
Press [PAGE] to display the second set of functions (when
available).
[F1 (LMTrk)]: Displays levels and meters of tracks.
[F2 (LM In)]: Displays levels and meters for inputs.
[F3 (LMAux)]: Displays levels and meters of the AUX and
EFFECT Send busses.
[F4 (→PRE)] / [F4 (→POST)]:
This switches the display of the meter from pre-fader to post-
fader. Press [F4] to switch back and forth between pre- and
post-fader levels. The current Levels setting is labeled either
“Pre” or “Post in the lower left corner of the center portion of
the display. If the current setting is pre-fader, you will see the
indicator “Pre” in the lower left corner of the level meter
display, and the label above [F4] will be “Post”. Pressing [F4]
at this point will switch the level meter to post-fader.
[F5 (→F/P)] or [F5 (→Metr)]:
This switches the display from Level Meters to Fader/Pan
positions for each channel.
fig.12-07
When the middle of the display is showing faders and
panning:
• Press [F1 (LMTrk)] to view the fader and pan positions
for the Track Mixer.
• Press [F2 (LM In)] to view the fader and pan positions
for the Input Mixer.
• Press [F3 (LMAux)] to view the fader and pan positions
for the AUX and EFFECT busses.
Cursor
Expansion in the level direction Expansion in the time direction
