92
Chapter 6 Mixer Channel Strip Detail
[F4 (FX4)] Effect 4 Send
Channel settings for the EFFECT 4 Bus. Sets the Effect Send
Switch, the Send Level (0-127) and panning.
Sw (Effect Send Switch)
Switches the channel to the EFFECT bus.
Off:
The channel is not sent to the EFFECT bus.
Pre:
The signal is sent to the EFFECT bus before it passes
through the mixer fader.
Post:
The signal is sent to the EFFECT bus after it passes
through the mixer fader.
Level
Sets the channel’s send level (0-127) to the EFFECT 4 Bus.
Panning
Sets the channel’s panning (L63-R63) in the EFFECT 4 Bus.
[F5 (AUX)] AUX Send
Channel settings for the AUX Bus. Sets the AUX Send Switch,
the Send Level (0-127) and panning.
Sw (Effect Send Switch)
Switches the channel to the AUX bus.
Off:
The channel is not sent to the AUX bus.
Pre:
The signal is sent to the AUX bus before it passes
through the mixer fader.
Post:
The signal is sent to the AUX bus after it passes through
the mixer fader.
Level
Sets the send level (0-127) of the channel to the AUX Bus.
Panning
Sets the panning (L63-R63) of the channel to the AUX Send
Bus.
If you are not using the VS8F-2 Effect Expansion Boards, the
effect send parameters will be replaced with additional AUX
send buses.
[F1 (FX1In)] Effect 1 Insert
After pressing [F1 (FX1In)], or moving the cursor to the
FXIns area, press [ENTER].
FX1 (Effect Insert Switch)
This sets how the effect is connected in the mixer.
Off:
The effect is not inserted in the channel.
Ins:
Both channels of the stereo effect are inserted into the
channel.
InsL:
The left channel of the effect is inserted into the mixer
channel.
InsR:
The right channel of the effect is inserted into the mixer
channel.
InsS:
Each channel of the effect is inserted in series into the
mixer channel.
* When Ins or InsS is selected, that effect cannot be inserted on
any other channel. When InsL or InsR is selected, that effect
can be inserted only on one other mixer channel. If the name of
an input or track appears as the Insert Switch setting, the
effect is already being inserted in the displayed input or track.
You will need to select the input or track that is using that
effect and turn its Effect Insert Switch off. Remember that
effects can be inserted in the MIX bus as well.
Snd (Insert Send Level)
This adjusts the level of signal (-42 dB to +6 dB) sent to the
effect. The default setting is 0 dB.
Rtn (Insert Return Level)
This adjusts the level of signal (-42 dB to +6 dB) returned
from the effect. The default setting is 0 dB.
