Filter
Top Products
MIDI Remote 249
03D—Owner’s Manual
Pro Tools Page
The following table lists the Pro Tools parameters that can be controlled from the 03D.
MIDI Channels do not have to be set.
1. Use the [MIDI REMOTE] button to locate the Pro Tools page.
2. In Pro Tools, choose Peripherals from the Setups menu.
3. Turn on DEVICE CS-10.
03D channel faders 1 to 8 correspond to tracks 1 to 8 on Pro Tools. Adjusting an 03D
fader changes the corresponding level in Pro Tools.
The Pro Tools transport functions can be controlled using the Rewind, Fast Forward,
Stop, Play, and Record switches. For recording, make sure that Pro Tools is set to Record
Enable.
Operation of the controls depends on the mode, as explained in the following table.
To adjust the pan, send 1, or send 2 of a Pro Tools track, set the mode to KNOB, select
a control, and then use the PARAMETER wheel. The corresponding parameter changes
in Pro Tools.
Do not operate the transport controls on both the 03D and Pro Tools.
03D Control Pro Tools Parameter
Channel faders (1–8) Track levels
[ON] buttons Depends on the selected mode
Display functions
Start, Stop, Record, Fast Forward, Rewind
Locate point recall
Pan
Send 1, Send 2
Mode Operation
SOLO ON/OFF switches are used to solo Pro Tools’ tracks
MUTE ON/OFF switches are used to mute Pro Tools’ tracks
LOCATE ON/OFF switches are used to move to the locate points set in Pro Tools
KNOB
The PAN, SEND1, and SEND2 controls can be used (note that these con-
trols can only be operated in KNOB mode)