Filter
Top Products
63
Recording a sound to a pad—Sampling
Recording a sound to a pad
Sampling from a pad to another pad
—Resampling
You can press one or more pads to play their samples and “re-sample” the result.
This is called resampling.
1. Press PAD RECORDING [PAD REC].
fig.31-05
[PAD REC] indicator begins flashing, and the
Sampling screen appears.
* If all pads already contain samples, a message of “Overwrite?” appears. In this case, press
[YES/ENTER], a message disappears.
fig.31-07c
2. Press CURSOR [ ] to move the cursor to
the “Start with” line.
3. Turn the TIME/VALUE dial to select “PAD.”
fig.31-09a
4. Press the source pad(s) and watch the meter
at the right edge of the screen while you
use the PAD/SEQ LEVEL fader to adjust
the level.
5. Press the pad to designate the sampling destination.
* If the specified pad already contains a sample, you will be asked “Overwrite?” If it is OK to delete
the existing sample, press [YES/ENTER]. If you wish to keep that sample, specify a different pad
that is unused. If necessary, press [PAD BANKS] to change the pad bank. (
➔ “Switching pad
banks”; p. 54)
6. Press [PAD REC].
The display will indicate “Waiting for PAD to start.”, and the CDX-1 will be in
sampling-ready mode.
To abort the procedure from this state, press [PAD REC].
7. When you press the source pad(s), sampling will begin automatically.
8. When sampling is completed, press [PAD REC].
The display returns to the Basic screen.
When resampling, you can
play a maximum of three
samples simultaneously.
For details on settings in the
Sampling screen, refer to
“Making settings in the
sampling screen” (p. 60).