Filter
Top Products
24
Using PCR Editor
The setting items shown in the message assign window will depend on the MIDI message you’ve selected. This section explains the setting items for each MIDI message. Values for
parameters are specified in decimal.
* Within the explanation, values in square brackets [ ] are in hexadecimal.
Clears any message assignment.
No message will be sent even if you operate a
controller that’s set to NO ASSIGN.
fig.EditorNoAssign.eps_35
NO ASSIGN has no parameters to set.
Assigns a channel message.
Use the Type field to select the type of message you
want to assign. According to the message you’ve
selected, set the following parameters.
Note [9n kk vv]
Assign a note message.
fig.EditorChannelMessage.eps_35
You can specify the following parameters for Note.
Channel Pressure [Dn vv]
Assign a channel pressure message.
fig.EditorChPres.eps_35
You can specify the following parameters for
Channel Pressure.
Parameter setting items
NO ASSIGN
Channel Message
Item
Content
MIDI Channel
MIDI channel [n]
Note Number Note number [kk]
Velocity Velocity [vv]
AFT Mode Aftertouch
Item
Content
MIDI Channel MIDI channel [n]
Min Value
Lower value [vv] of channel
pressure
Max Value
Upper value [vv] of channel
pressure
PCR-300_500_800_e.book 24 ページ ２００６年１２月１９日 火曜日 午後２時５９分