Filter
Top Products
42
Settings (Edit mode)
Here’s how to assign a note message to a controller. Note messages are used in a performance, and can also be used to control DAW software.
Basic editing (->
Advanced editing 1
(p. 43))
fig.H-Edit.eps
1
Press the [EDIT] button so it’s lit.
fig.D-Edit.eps
The display will indicate “EDIT.”
fig.D-r1.eps
2
Slightly move the controller to which you want to assign a note
message.
If the controller is a button, press it.
The display will indicate the number of the selected controller.
3
Check the indication in the display, then press the [ENTER] button.
fig.D-Note.eps
4
Turn the VALUE knob to make the display indicate “NT” (Note
assign).
5
Press the [ENTER] button.
fig.D-NoteEdit0.eps
6
Turn the VALUE knob or press controller [A1 (0)] to get the “NT0”
indication for basic editing.
fig.D-ChannelSelect.eps
7
Press the [ENTER] button.
The display will indicate “CH- -.”
* The - - portion shows the currently specified value.
8
Enter the MIDI transmit channel.
Use the VALUE knob or controller [A1 (0)]–[B2 (9)] to specify the desired channel.
fig.D-NoteSelect.eps
9
Press the [ENTER] button.
The display will indicate “N- -.”
* The - - portion shows the currently specified value.
10
Enter the note number. Use the VALUE knob or controller [A1]–
[A8] and [B1]–[B8] to specify the desired note number.
11
Press the [ENTER] button.
12
If the controller is [A1]–[A9], [B1]–[B9], [C1]–[C3], [L1]–[L4], or [P1], specify the
button mode (p. 64).
Note assign
Editing
Controller Display
MIDI transmit
channel
Note number Velocity Port Button mode Aftertouch
Basic editing
[A1 (0)] 1–16
0–127
(00–7FH)
100 (64H)
(fixed)
PORT1
(fixed)
Unlatch/Latch OFF (fixed)
Advanced editing [A2 (1)] 1–16
0–127
(00–7FH)
0–127
(00–7FH)
PORT1,
PORT2,
PORT1+2
Unlatch/Latch
OFF,
Channel Pressure,
Polyphonic Key Pressure
PCR-300_500_800_e.book 42 ページ ２００６年１２月１９日 火曜日 午後２時５９分