Filter
Top Products
59
Settings (Edit mode)
Specifying the location of the data
As described below, you can specify the location and type of the variable data to be inserted in the system exclusive message.
For basic editing and advanced editing 3, the range of data values will be the default range. For advanced editing 1 and advanced editing 4, it will be the range specified by the user.
For a specific example, refer to
Master Volume
(p. 62).
1
Press the [DATA] button at the location where you want the variable data to be inserted.
The display will indicate “DT0.”
2
Use pads [0]–[4] to select the type of data.
* In the case of DT1–DT4 (data that occupies two or more bytes), a data area will automatically be allocated for the following byte(s), and the display will indicate “-DT.” (This cannot be changed.)
3
Press the [ENTER] button.
If you selected DT1 through DT4, the display will indicate “-DT.”
4
Press the [ENTER] button.
Data number
Data type Default range Target of range setting
Example (specified minimum
and maximum value)
DT0
7bit 00H–7FH Specify the data range (00H–7FH) 04–45 (minimum 4H, maximum 45H)
DT1 4bit/4bit 0H/0H–FH/FH
Specify the range of the first byte (0H–FH).
Second byte is fixed at 0–FH.
0/0–D/F (minimum 0H, maximum DH)
DT2 7bit/7bit (MSB/LSB) 00H/00H–7FH/7FH
Specify the range of the MSB (00H–7FH).
LSB is fixed at 00H–7FH.
23/00–68/7F (minimum 23H, maximum 68H)
DT3 7bit/7bit (LSB/MSB) 00H/00H–7FH/7FH
Specify the range of the MSB (00H–7FH).
LSB is fixed at 00H–7FH.
00/23–7F/68 (minimum 23H, maximum 68H)
DT4 4bit/4bit/4bit/4bit 7H/FH/0H/1H–8H/0H/FH/FH
Specify the range of nega-
tive and positive as 00H–
FFH centered at 8000H.
7/F/0/2–8/0/5/0 (minimum FEH, maximum 50H)
8000H
FFFF
max
min
PCR-300_500_800_e.book 59 ページ ２００６年１２月１９日 火曜日 午後２時５９分